1. What are the precautions for the use of mountaineering sticks
1. During the long -term Hiking, check whether your cane is locked frequently to prevent the donkey from being "hoof" before.
2. Try not to insert mountaineering sticks into water with high calcium content, such as Huanglong and Jiuzhaigou.Otherwise, it will corrode the cane or it is difficult to clean up.

3. Walking on the mountain road, when there is a cliff on one side.Be sure to use the Climbing stick on the side of the mountain, otherwise it is easy to danger! Usually you must develop the habit of using a cane with your left and right hands.
4. On the steep road, try to stay away from the people who use climbing sticks in front of you, otherwise you will be blinded by blind eyes.
5. The Climbing stick is not a magic pestle or a diamond stick. It is gentle for it. If the violent use of the rod is also broken, it may be dangerous.
Section 6 and 3 of the pantamosis Stand 2 Section 2 In the adjustment length: The length of the following 2 sections should be as long as possible, so as to evenly disperse the strength to avoid damage caused by one of the sections and the concentration of strength.Some styles of cane will have a scale.
2. How to maintain mountaineering sticks
1. When the Climbing stick falls into the water or is humid, please pull it out for drying;
2. In order to extend the life of the Mountaineering stick, please disassemble the climbing rod after a long time or go down the mountain and put it away after wiping.
3. If a Mountaineering stick is rusty, a very small amount of rust removal agent can be used to treat the rust on the surface, but before use, you must remove all the oil on the surface, so that it will not affect the adjustment of the Climbing stick.Lock function.In addition, you can also use very fine scrub paper to remove rust on the surface, and keep the lock function of the climbing rod is not affected.
Using the rotating locking rotary Mountaineering stick may be dropped by the powder rust of the rod, blocking the locking rings, which affects the locking effect. ThereforeBefore using it, be sure that the inside is very clean, without any rust and oil.
4. The locking system of the aluminum alloy Climbing stick will not be unplugged. You can gently pat the locking part, or wet the Climbing stick to reduce some friction, and then you can smoothly open the Climbing stick to open the rotten stick.EssenceAfter the spin is turned on, the opening must stand upright, let the water inside flow out slowly, and dry and store the Climbing stick separately.
5. When the rotating Climbing stick is locked, the rod in the strap will rotate with the support rod and cannot be locked. You can remove the rod, and then clean the rod thoroughly before loading it back.If you ca nt lock it, after disassembling the rod, turn the thinner pole into the rod to support the rings, and then directly insert it into the thicker bang, adjust it to the desired lengthLock afterwards.
Third, common problems and maintenance of mountaineering sticks
1. Common situations with high frequency of mountain climbing: obvious wear of the tip of the stick
Friends who often climb mountain climbing, pay special attention to the tip of the rod of the mountain rod.This is the case, regardless of the intermediate and alpine mountains, there are environmental changes with rich terrain, such as: soil and stone lanes, gravel rocky slopes to maintain a balance of balance.It will gradually increase the wear of the pointed tip because of "long -term hard touch", which is also a normal loss.So when you often use mountaineering sticks in such a terrain, please check if the tip of the stick is too serious before departure?Please repairs the tip of a new stick to ensure safety!
2. The common situation of the Mountaineering stick for too long: The preservation method is wrong
I only used a Mountaineering stick for a long time. I want to see when the last time was used?The things that everyone often says will be broken for too long. The common examples are: the shoes have not worn for too long, causing the sole to be brittle and dehydrated, the camera is too long to cause dust or unable to turn on.You will find that this also has a lot to do with the way of preservation.If you want to keep the rod, you can keep it like a new one, so be sure to do a good job of maintenance and preservation of mountaineering sticks!Pay attention to the dirt and dirt that is placed in a dry and ventilated place, cleaned the dirt on the mountain climbing stick, and when stored, please turn the pine Climbing stick appropriately, so that you can bring a good Tool with a good look at the same time!
3. I dont know why the foot pads are worn/worn
The foot pads are usually suitable for smoother roads, which increases friction with the ground by pads, and is also a accessory used to protect the tip of the rod.But if you have been used in the geological and rugged terrain for a long time, if you do nt remove the foot pads in a timely manner, it will cause the hard stick tip over time to accidentally wear or even wear the foot pad.Next time I remember to change the use of accessories at any time, it can increase the life of the Climbing stick!The stone steps and wooden boardwalks can be used on foot pads; gravel, mud, etc. can be used to increase support with the tip of the rod
4. The Climbing stick is often locking tightly
Recently, do nt use the Climbing stick, do nt lock the Mountaineering stick aside!The best way to storage of rotating climbing rods is to lock it slightly. It can be relaxed moderately, which can be placed flat or directly in a dry and cool place.It will not make the lock system accelerate fatigue because it is always locking.
5. There is no cleaning/checking mountain climbing stick home
At the time of the departure, the big sun was gone, but it suddenly turned to a cloudy day and a little drizzle, which made the moisture on the mountain heavier. Maybe the Mountaineering stick was stained with a lot of mud?Please remember to remove each piece of stick, wipe off the mud, and clean the Mountaineering stick to avoid letting the dirt quietly hidden in the Tube for too long and cause the odor to produce.Stir down the cool place.If you are just too lazy to clean up the equipment, the soil cumulative dirt remaining in it may also cause some accessories to oxidize the material. Because the dirt that has not been cleared for a long time can also make the Climbing stick stuck in difficulty, it may be necessary to repair the Climbing stick.Even a new one.For a long time, the mud that has not been cleaned for a long time, there is a sludge part of the threading part of the mud shield, so it will be more difficult to lock the mud board.