How does the hair band look good?
1. The method of the bow hair band
1. First sort out the hair.
2, A dividing line is opened in the bangs, both sides are the same.
3. Because the hairpot band is relatively wide, it can also be half a discount.
4. Grab the hair into a ponytail.
5. Then put the hair hoop in the ponytail from the bottom up.
6. Then cross the two sides of the hairband band and fold it.
7. Turn around each other.
8. In this way, a cute rabbit ear is completed, and you can also fold the rabbit ears a little bit a little bit, which will be more cute.
9. Then if you want to make a bow, you can directly fold the rabbit ears to the point where the ears are twisted.
10. Both sides are done, and a sweet bow is formed.
11. Then you need to sort out the overall hairstyle, tidy the back of the back to the forward, cover the hairband hair band.
12. Then dial some bangs at the bangs, so that the hair hoop is completely covered with the hair hoop.The overall beauty is much more beautiful, and the beautiful eyebrows will show a small face ~
13. The butterfly hairpot hair band is done like this, it is very sweet and pleasant.
two, Patting of the Mawei Band
1. First divide the rear hair into the upper and lower parts.
2. Put the hair with rubber bands in the middle of the two layers of hair.
3. Adjust the front position of the hair to the top of the head, and push forward with the four fingers of each side, which will cause fluffy effects.
4. Grab the hair outside the hair band and roll up with the hair inside the hair band.
5. One or two laps around the Hair belt.
6. On the other hand, the hair is compiled in the same way, a ponytail is tied, and the rubber band is pulled down.
7. Use two index finger to divide the hair on both sides.
8. Go into the ponytail and complete.
Third, the method of wearing the ancient wind hair band
1. Comb the hair with a comb, comb the hair smoothly, and then divide the hair behind the head into the upper and lower parts, tie the hair on the upper part, and then take a Chinese style hair band to fold and pass through the hair beam.
2. Tie the hair band and tighten.
3. Turn the hairband to make it look more natural.
4. After finishing the hair, divide the hair behind the head into two parts, and use the rubber band to tie the hair on the upper part.Fold your hair band and pass through the beam.
5. Pull a small mouth in the place where the hair zone is folded and pass the tail end of the hair.
6. After tie the hair band, tighten it. If you are too loose, you can use a clip to fix the hair band and the hair beam. Finally, adjust the hair band with your hands, which looks more beautiful.