1. Is it good to hit the pole before the fishing rod is changed?

The front pole is a type of hand and sea dual -use pole. It is named because it is suitable for the "front fishing method".Through the transformation and modifying into a pole, can you hit the pole before changing the fishing rod?

It is more convenient to change the pole before the fishing rod. Compared with changing the rod, it is better to hit the pole before changing, because the wire rings of the front pole are small, it is not easy to wiring, and it is more conducive to Taiwan fishing.The body is relatively light; in addition, after the Taiwan fishing rod is changed to the pole, there are enough lines when encountering the big fish, which can ensure that when the big fish is struggling, it will not be cut like a limited line group of the Taiwan fishing rod.And the pole can be caught deeply.

In summary, it is better to change the pool before the fishing rod is changed. So how to change the fishing rod to the front pole?

2. How to change the fishing rod before changing the pole

Pay attention to the method before changing the fishing rod. Generally, the modification requires 502 -speed dry glue, epoxy resin glue, guide ring, top slow, fishing wheel card seats, high horse lines, front wheels and other materials.The modification method is as follows:

1. Put the rod tip of the table fishing rod with a lighter and remove it.

2. Then use 502 glue to stick the guide ring from small to large to the pole mouth.

3. After the glue is dried, you can use a parallel tied ring with a parallel horse line to tighten the fishing wheel on the fishing rod.

4. Then use sandpaper to polish the inner diameter of the activity, so as to avoid scratching the fishing rod paint surface when closing the pole, and the number of activity conductors installed installed in the specific length of the pole tip can be selected according to the length of the pole tip.

5. Apply 502 glue to the tip of the pole to install the top ring.

6. Then the epoxy resin glue is divided into two bottles of two A and B bottles of 1: 1 and evenly apply it evenly on the high horse line.

7. After applying a well, you need to stir up for more than 24 hours and then wrap the anti -slip tape, and then put it forward to hit the wheel.