1. How to wear the curtains

1. Small pleated wear method

Put on 1, 2, 3, and 4, that is, the four-to-teeth hook's 4 inserted pins are inserted on the serial number 1234 hole on the cloth band, respectively.4 holes.

2. Mid -fold traditional wear method

Put on 1, 2, 4, and 5, that is, the four -to -teeth hooks are inserted into the target number 1245 hole on the cloth zone, and 1 hole is separated by the interval, and the third fork is worn; the two hooks are separated by 4.-6 holes, generally 7-8 miracles per meter.

3. South Korean wear method

You can also wear two more than one, and you can also wear two more, so the effect is more prominent, but the more the amount of the cloth is used. After the hook is put on to the bottom of the cloth Belt, the hook is tied.Fold the folds so that it is facing the front. In actual use, you can adjust the number of inserted places inserted into the slot.

4. Big pleated wear method

It is recommended to wear 1, 3, 8, and 9, that is, the four -to -teeth hooks are inserted into the serial number 1389 hole on the cloth Belt, and 4 holes are separated by the middle of the middle.-8 holes.The folds of the curtains look a bit like a butterfly shape.

two,How to hang the curtain hook

1. First of all, find the position above the curtains, and observe it carefully. You can see the gap. It is a double -layer and there are special hooks.

2. Hang the hook in and pay attention to the position of the folds.

3. Leave the folds, then hung the hook completely and lift it up.

4. The hooks on the curtain rod are put on, and then the hook is prescribed later.

5. Gather the hooking place in one place to facilitate the hook.

6. Follow the sequence of the hook and hang the hook.

7. After Hanging up, the curtains are hung up.

1. Cable link model

General cable hooks are linked to mineral cables. The specifications are 20, 30, 40, 55, 70, 80, 100, and 5 hooks and 8 hooks.

<table style="width:80%;" cellpadding="2" cellspacing="0" align="center" border="1" bordercolor="#000000">

IA

hook length (mm)

Maximum tension (n)

8 2

166 2

4100

20 2

110 2

4100

30 2

122 2

4100

40 2

127 2

4200

50 2

144 2

4200

60 2

156 2

4200

70 2

167 2

80 2

189 2

100 2

209 2

84 2

40 2

60 2

77 2

table>

2. How many meters are the cable hook per meter

In the telecommunications engineering budget, the cable is hooked about 50cm to put one. To be precise, it is linked to 2060 cables per 1km.

ConstructionGenerally, one interval is 0.6-0.8 meters.

Third, cable hook installation method

1. Select the suitable cable hook according to the cable model and outer diameter. Every 1.2m to 1.8m (can also be limited to the cable is not drooped) as a suspension unit, each unit is linked to one or more cables according to one or more cables.

2. During the suspension, first fix the hook on the wall of the well. When the hook is fixed, the arc hook is vertically drooping when the hook is fixed.If multiple cable Hanging, one set of hooks and two skewers must be adopted.The construction personnel first connect the hooks on the ground, and then fix it according to the previous method.

3. When the two hooks are connected in series, first align one hook hole to align with another hook rod, press it hard, so that the Hanging rod enters the holes completely, and then rotate with the arc hook to make the two hook straight rod sections become sections.180 .

4. After confirming that the cable enters the curved hook as a whole, the construction staff can let go of the cable.

(1) Each unit can be linked in series and the number is not easy to exceed 10.

(2) In order to improve the quality of the suspension, the hooked straight pole segment is best to close the well -closed during static.

(3) It is strictly forbidden to quickly send the cable into the arc hook by the volley jumping method, which may make the curved hook to withstand the weight of the cable and the human body in an instant, causing a break.

(4) After confirming that the cable overall enters the curved hook, the construction staff can let go of the cable.

1. The difference between linked curtains and punching

1. Applicable place

Pole curtains are generally suitable for large -area windows, such as to separate the living room from the balcony.If it is a floor -to -ceiling window, it is also very suitable for using punching curtains.The linked curtains are generally used for four -claw hook and S hook. If this curtain is suitable, all occasions are suitable, but many people still use it in the bedroom.

2. Disassemble

The curtains also need to be disassembled regularly, because long -term suspension, a lot of dust will fall on it.In terms of disassembling and washing, punching curtains are easier to disassemble. Take the curtains and Hanging rods together, and then take the curtains from the pole.The linked curtains will be more troublesome if it is removed, because it is necessary to remove all the hooks before being washed.After cleaning, when Hanging, it is also very time -consuming to install these hooks and reinstall it.Relatively speaking, the hook cleaning and installation are more troublesome, and the punching curtains should be much easier.However, when cleaning, the thickness of the hole curtains is thicker, and the difficulty of cleaning has increased a lot.The hook curtains should be thinner, not so difficult to clean.

3. Beautiful

Generally speaking, the prices of punching curtains are more expensive.The overall feeling of the punching curtains is very good, and it looks very atmospheric.Overall, punching curtains should be more beautiful and stronger, and can enhance the sense of grade of space.The overall sense of the linked curtain is not so good, and the price is relatively cheaper.Although the hook can determine the amplitude of the curtain folds, it is still a bit inferior.

4. installation method

There are still obvious gaps in the installation method of linked and punching curtains. The hook requires you to calculate the distance measurement in advance.Then you need to adjust the number of inserted pins into the slot. Generally, there are 3-4.After that, you need to consider the number of caves in the middle, which is more troublesome.The installation method is very simple in installation. You only need to put on the hole of the curtain into the pole at one time.

Pole -and -hook curtains have their own benefits. Good or bad depends on personal preferences.They have their own advantages and disadvantages. When choosing, they can choose according to the place to be installed and the decoration style they designed.

2. How to install the hook curtains

1. installation of the top seat

After the location of the curtain linked is determined, take the drill drilling hole. After the drill is drilled, the expansion screws are fixed to the four top seats (if the pole grows greater than the conventional size, this length is adjusted accordingly).

2. Install the curtain ring corner

The curtain linked angle can be installed on the top of the balcony or the top of the wall, and the corner is 50--70cm from the top seat of the activity. It is necessary to form a triangle (45 degree angle) and the position of the shaking hands in the middle of the top seat to maintain the same vertical line.

3. Steel wire connection

A set of curtains contains two steel wires. Take out one first. First, the end of the steel wire through the corner bearing wire groove, and then pass through the active wheel bearing wire slot on the top seat, and then pass through the fixed top top seat.The bearing wire groove makes the wire vertically on the ground, and then puts the top cover from the wire to the top cover.The other end of the steel wire is the same.Another steel wire installation method is the same as root.

4. Curtain rod connection

At the end of each steel wire, wear a Hanging ball and knots in the Hanging ball; then pull the Hanging ball until the top seat is held.On the side of the shake; relax the steel wire in the hand shake, the Hanging ball drops, pass the curtain rod through the Hanging ball, and then tighten and fix it at the position of the Hanging of the Hanging ball, nail the screw;Cover.In this way, the installation of the curtains is successful.

3. precautions for the installation of curtains

1. When installing the curtain hook, the distance between the hooks should be as uniform as possible, and the calculation is calculated first.

2. Pay attention to the rusty hook, you should change it immediately to avoid polluting the curtain cloth.

3. In actual use, you can adjust the number of inserted pounds, 3, or 4; you can adjust the number of Hanging grooves between the interval between each two hooks, so that the effective width of the curtain can be adjusted.