1. Electric Barbecue oven indicator is not on

maintenance method:

1As well asPower plugs are not in contact with sockets, and plugs and sockets should be replaced or repaired.

2As well asThe power cord core is broken and the power cord can be replaced.

3As well asThe thermostat contact is burned, repaired or replaced with the thermostat.

4As well asPoor contact head in the timer, repair or replace the contact.

Second, the electric Barbecue oven is not hot

maintenance method:

1As well asConfirm whether the indoor power supply is out of power.

2As well asCheck whether the power cord of the electric barbecue stove is disconnected, and whether the power plug and the podium are poor.Find out the disconnect and pick it up again, and wrap it in the insulating gel cloth.If the plug and socket are damaged, it will be replaced.

3As well asCheck whether the heating device is loose, and whether the heat of the heating device and the socket is good.Poor contact, recreate.If damage is severely replaced.

4As well asThe electric wire is burned.Replace new products with the same specifications.

5As well asThe switch touch of the switch, the temperature regulator, and the timer loses elasticity;;The contacts are severely abstructed or poorly exposed.Find damaged parts to repair or replace new products with the same specifications.

Third, the temperature controller of the electric Barbecue oven fails

maintenance method:

1As well asThe thermostat tactile loses elastic or contact bonding.Replace the losing elastic tactile or use a fine sand cloth to repair the contact.

2As well asThe rotating thread Sleeve is rotated with the rotor, and the position of the fixed touch cannot be adjusted.Fixed thread cover.

3As well asThe porcelain beads on the dual metal tablets are damaged or falling off, causing the dual metal sheet to reach the tactile tactile.Replace porcelain beads or tight porcelain beads.

4As well asDouble metal pieces are damaged.Replace new products with the same specifications.

Fourth, electric barbecue furnace time switchdamagebad

maintenance method:

1As well asDelivery or bonding.Use fine sandpaper to be carefully polished and Smooth.

2As well asThe springs are weak and replaced.

3As well aswatch spring or gear damage and replace the damaged parts.

5. The electric barbecue stove door is stuck or closed

maintenance method:

The stuff of stuck in the furnace door is that the door bead protruding too many spring boxes, the stuck cannot be shrunk, and the door bead is adjusted again.

The main point is that the spring is weak, loses elasticity, and replaces new springs.

6. Electric barbecue furnace door glass damage

maintenance method:

The main reason for this kind of failure is that the pressure screw is pressed too tightly, or the glass door is drenched by cold water during high temperature baking.

Use heat -resistant glass to replace according to the original specifications, and avoid the above conditions when used.

7. Electric Barbecue oven leakage electricity

maintenance method:

1As well asThe sealing and insulation material of the heater to withstand the high temperature and reduce the insulation performance and cause the leakage, re -sealing.

2As well asThe heater socket has electrical dirt to reduce its insulation performance, and wipe the electrical dirt with a dry cloth.

3As well asConvert switches, insulation switches or timing switches to reduce the insulation performance, and perform dry treatment.

4As well asElectric deep lines or plug insulation layers are damaged and replace new products.

5As well asThe wiring head was loosened and touched with the shell, and the loosening head was picked up.