What are the precautions for the use of sea rods?
1. What are the use of sea poles
1. Open it by sectionSea pole, Align the coils, and on a straight line, the connections of each section should be slightly tightened.Cross coils should be a quasi -winding wheel card.
2. The baying wheel, the winding wheels will be on the card seat, fix it to death with a nut,
Dial the winding wheel to the reverse position, pull the wire head, pull out the fishing line, and then pass through the coil one by one until passing through the tip of the pole.Then use the connecting ring to hang the aconite and bomb bait to prepare for throwing.
3. Dial the inverse switch back to the positive rotation position and adjust the drainage device, which is very important.Too tight, the resistance of the qualifying is too large, and it is easy to break the line when encountering a big fish; too loose, the line resistance is too small, and the line is too fast when encountering the big fish.Usually pull the fishing line by hand, you can pull the fishing line.
4. Rotate the rotation wheels to make the bait ball from the tip of the pole 30 ~ 40 cm.Then hold the pole at the rod of the rim, and the middle finger and the ring finger are sandwiched to the back of the wire. The first joint of the index finger hooks the fishing line and flip the line ring.
5. After the aconite falls into the water, immediately remove the circular ring and shake the wound wheel handle to close the line. When the closing line is retracted, the fishing line is still relaxed, and the sea pole is placed on the bracket.It should be larger than the ground), that is, it should be steep.Generally speaking, the greater the elevation angle, the higher the sensitivity; otherwise, the slower.It is the right standard to judge whether the elevation angle is suitable for the angle between the Fishing rods and the fishing line. When the angle is closer to 90 , the more sensitive the response.Therefore, this angle is the core of the response sensitivity.After the sea pole was supported, a small bell was then pinched on the tip of the pole.
6. If you encounter heavy winds, the corners will make the fishing rod easily influenced by the wind.In order to enhance the anti -wind resistance capacity, the elevation angle can be reduced, but it cannot be too small, which will reduce the sensitivity of the pole tip. In addition, the sea pole can be recovered several sections, which can reduce the pole to the high and reduce the impact of the wind;Or lie on the side of the sea pole on the shore, but pay attention to the angle between the fishing rod and the fishing line, so that it is close to 90
7. After the sea pole is supported, you can see the reaction, or listen to the ring, or look at the tip of the pole.When you see the sharp swing or ringtone, you can turn a loser to raise the pole after holding the pole, and then quickly close the line. After receiving a few meters line, you have to raise it once again.fish lips.
8. After the bait enters the water, there is still no response after 20 ~ 30 minutes. At this time, you should start and change the bait.Because the bait will spread out shortly after entering the water. After half an hour, the bait will be eaten by small fish, and it will take time in vain without changing the bait.
2. What are the precautions for the use of sea poles
1. Do not forget to turn on the line when throwing.The adverse consequences caused by the implementation of the throwing action without opening the online file are obvious.Some bomb hooks have become "Sky Girls Sanhua", and some are broken and broken.
2. Do not stay for too long.The drooping line refers to the distance from the section of the pass from the tip of the sea pole to the bomb hook.The drooping line is generally about 30 cm. Too long down the line will seriously restrict the throwing movement of the sea pole.Weeds and the like.Therefore, even if the hooks and bomb hooks are used together at the same time, it must not exceed 40 cm.
3. Do not twist the fishing line wheel too tightly.Turn it too tightly and let go of it.The drainage of the fishing line wheel is twisted too tightly, and when the fish is hooked, there will be a danger of Fishing rods.
4. Don't meet people and fish prematurely or copy the fish prematurely.Early, the big fish pulled the big fish near the shore and exposed the water, and the fish would struggle desperately. At this time, the struggle would be much greater than when it was hooked.The correct approach should be to harvest the wires, repeatedly catfish, until the big fish belly turns white and copied fish into the net.But be careful not to get fish in the waters of the barrier.
5. When choosing a fishing position, try to avoid weeds, peanuts, branches and the like in front of this waters, because these obstacles will affect your catfish.
6. Do not buckle from top to bottom when copying fish, because there are still hooks and wires in the fish mouth, copy from top to bottom, no matter how to copy the fish.The correct way should be the left hand holding the rod, the right hand holding the net, and the direction of the left hand, and the right hand sinks the net under the big fish in a timely manner.When the left hand is walked to the net port and sinking the fish head, at this time, the right hand holding the net is quickly copied and copied the big fish into the net.
3. How should the sea pole be maintained
1. If there is a sea rod with a bottom cover, open the back cover and pull out all the sea rods. Don't pull too tightly.Dry or dry in a ventilated place.
2. The sea pole without the back cover is pulled out of three -quarters of each section. Put it in a ventilated place to dry or dry, so that the water evaporates from the gap between the two sections.Dry.
3. If it is rainy weather, the humidity in the air is very large, which is not conducive to the evaporation of water.You can pull out half of the sea rod and heat it flat on the electric Mattress to evaporate the moisture.
4. When the sea pole falls in the sea, it is necessary to fully wash it with water in time, and then dry it, because the seawater is more corrosive to the fishing rod.The wheels must also be cleaned with water, because the seawater is more corrosive to metal.