How to make eggshell Fertilizer

1. Use eggshells to make solid Fertilizers

1. You can first wash the eggshell with water and cook it with boiling water to make disinfection effect better.

2. clean the eggshell and sun exposure under the sun. At least one week should be bask, and the water in the eggshell is completely dried.

3. After drying, use a cooking machine to break into powder. When preparing potted soil, mix some eggshell powder into the base Fertilizer, and the amount can be about 10 %.

PS: Using crushed eggshells as topdressing, you can dig pits directly on the surface of the pot soil and bury the eggshell powder into the soil.Note that when using eggshell powder as topdressing, it is not appropriate to sprinkle directly to the surface, and the hypertrophy cannot be absorbed by the root system on the surface of the pot soil.

Second, use the egg shells to make organic liquid Fertilizer

1. Broken the eggshells in the above method, pour it into the bottle, and add an appropriate amount of water.

2. There is a little more water than the eggshell, which can flood the eggshell.

3. Finally cover the bottle cap to ferment the eggshell, it takes about two months to ferment.

4. Because a large amount of gas will be generated during fermentation, the bottle is needed from time to time to breathe.

5. It is recommended to mix the eggshell with other Fertilizers. The content of the composition in the Fertilizer will be richer. In the later stages of the system, add the fruit Skin such as a single orange Skin to effectively eliminate the organic liquid Fertilizer.Smelling can also strengthen acidity ingredients in Fertilizer.

6, fermented eggshells can be used directly as flower Fertilizer.

The role of egg shells as Fertilizers

1. The content of calcium carbonate in eggshells is quite high, and the content of phosphorus is also very high. It can be regarded as a kind of phosphate Fertilizer.The role of phosphorus Fertilizer is to make the trees and stems tough, promote the formation of flower buds, large flowers, and precocious fruits, so that the trees have more new roots, good growth and development, improved cold resistance, and drought resistance.When the use of insufficient phosphate Fertilizer will grow slowly, resulting in small leaves, branches, or division reduction, small flowers and fruits, mature late, and the veins of the lower leaves will be yellow and then purple -red.

2. When trees lack phosphorus, the manifestation is usually the first disease.Organic Fertilizers with more phosphorus include Bone powder, rice bran, poultry feces, fish scales, etc.Inorganic phosphate Fertilizers include calcium phosphate, phosphorus powder, and calcium magnesium phosphate Fertilizer.Among them, the most commonly used is calcium phosphate, which is often mixed with Organic fertilizer as base Fertilizer, and can also be used as the root of flower and fruit bonsai.Excessive calcium phosphate should be used for neutral or microbians, and it is not suitable for acid soil.

Pay attention to flowers and fat with eggshells

1. Do not use the amount of flower Fertilizer with eggshells to do too much, and cannot exceed 15%of the total nutrient soil. Too much, it will affect the growth of the flower root system and the absorption of nutrients.

2. Try not to use eggshells to make flower Fertilizer as much as possible. If the operation is not good, it may also be counterproductive.For secondary fermentation, it will cause roots.

1. How to cultivate Jin Xinxiang Dragon Blood Tree

1. Change pot

Brazil's wood grows fast, consumes more nutrients, and most of the trees are small.From March to April of the early spring every year, change the basin to fertilize, remove the old plant, remove some dead old roots, replace the large number of Flower pots, add new cultivation soil, pile up Fertilizer or 4 to 5 hoof corner slices, Pour water after planting.

2. Fertilizer managementFrom June to September, every 15 days is appliedCompound fertilizerOr cake Fertilizer water, nitrogen fertilizer should not be too much, otherwise the stripes of flower and leaves will fade.Watering in the pot should be dried and wet. Generally, 3 cm deep in the pot soil is dry and then watered.Water is poured once a day in summer. The room temperature in winter is 15-20 C, and water is poured once every 5 to 7 days.

Second, the method of breeding of Jinxinxianglong Blood Tree

1. Temperature: The optimal temperature required for the growth of Xianglong Blood Tree is 20-30 C.When the temperature is lower than 13 C, the plant enters the sleep. If it is in 5 C for a long time, it will cause freezing damage; therefore, at low temperature, the trees are sprayed with trees to keep the troops warming and anti -freezing, disinfection and sterilization, and make it safe in dormant.

2, humidity: Xianglong blood tree is wet, afraid of waterlogging.Leaf growing is strong and keeps the pot soil moist, but the potting soil cannot accumulate water. The air humidity is 70 % to 80 %, and a new high -fat film is sprayed on the leaf surface.Watering should be controlled during dormancy, otherwise the leaf tip is prone to the phenomenon of leaf tip.

3. Light: The fragrant blood tree is more adaptable to light. Under the condition of sufficient sunlight or semi -yin, stems and leaves can grow and develop normally.Therefore, full -day photos can be accepted in early spring and autumn, and shade should be shaded in summer. In addition to controlling the amount of watering in the end of autumn, spray 0, 2%to 0, and 5%of potassium dihydrogen phosphate to improve its ability to cold resistance.

4. Soil:If you want to make Xianglong Blood Tree better, you must try to choose the soil that is suitable for it. It is best to use a more loose and fertile sandy loam soil.The drainability of the soil is also not good, which can prevent rotten roots due to water accumulation.You can use peat soil and river sand to prepare and use it, and you can add an appropriate amount of Bone powder.

3. precautions for the breeding of Jinxinxianglong Blood Tree

1. Pruning: Xianglong Blood Tree is resistant to pruning. It can control the height and shape of the plant by trimming. For trimming the wound, it is more injured and disinfected with corruption membrane, preventing dry cracks, and promoting wound healing.In order to make the leaf buds grow strong, the basin must be changed every spring. The new plant is changed once a year.Usually cut off the aging and withered leaves in the lower part of the bush, spray trees to prevent the infection of the bacteria.

2. Prevention and treatment of diseases and insect pests: Xianglong blood trees are generally not prone to diseases and insect pests, but when the environment is poorly ventilated, it will cause pests such as granice insects and red spiders.Usually open windows to make the balcony or indoor ventilation well to prevent pests from occurring.When the harm of pests is found, 40%oxidation music can be used with 1000 times liquid, 2.5%bromide 2000 times liquid, and an appropriate amount of new high -fat film into a mixture, which can greatly increase the utilization rate of the effective ingredients of pesticide Fertilizers.Effects more than 300%.It is best to spray the ground on the ground to spray and apply it at the same time for prevention and treatment.

1. The cultivation method of Overlord plum

Bawang plums mostly use cuttings. If there are greenhouses, it can be reproduced in winter, spring, and autumn except summer.

1. Cut into the spike from the top of the relatively mature branches, 5 to 10 cm long, put it in a cool place for two days, and cut the cuttings when the branches are slightly soft.

2. The size of the sand bed depends on the number of branches.Smooth sterilization and disinfection prepared in advance (can be used with multi -bacterial spirit and potassium manganate). The cutting spacing of the cuttings is 5 5 cm, and the depth is one -half of the cuttings.

3. After inserting, spray water a little every day, set up a small arch of plastic arch, and ventilate appropriately.

4. After five or six days, the cuttings base tissue gradually healed and sprayed water.

5. In the future, spray water to see dry and wet, take root after about two months.When the root system is fully developed, it can be transplanted and put on the pot.

Second, the breeding method of Overlord plum

1. Overlord plum can be cultivated in greenhouses all year round, and in Beijing from May to September can also be planted and open -field potted plants.It does not stain water in summer, but it can grow normally in drought.If it is made of flowers, potted plants are still easy to manage indoors and grow better.

2. Requirements for soil: Suitable for sandy soil with good permeability, not suitable for sticky soil, afraid of water staining, cultivate soil pay attention to add coarse sand, furnace ash or perlite.Overlord plum is more resistant to drought, not strict with soil acid and alkali, and slightly acidic and light alkali can grow normally.

3. Requirements for water: Watering should be dried through.Generally, the drying and high temperature season should be poured once a day.winter in winter, water once every morning in a sunny morning.Low temperature, cloudy days, and greenhouse air humidity is too large or not to be watered.

4. Overlord plums are not strict with Fertilizer. In addition to the cultivation of one -third of the grass charcoal or humus, it usually applies dibamine or other long -effect sustained -release compound Fertilizers every two or three months in the pot.Change to the largest basin in April or September of each year, add some new cultivation.

3. Diagnosis and Treatment of Overlord Plum

1. Diseases: Some of the main diseases are targeted at leaves, such as "leaf spots" and "anthracnose" and so on.Generally speaking, there are more in summer and autumn, especially when the ventilation conditions are not good.It can ventilate and see light, and use potions at the same time, so that the effect of prevention and control is good.

2. insects: "Aphids" and other are more common, which can be sprayed with oxidation and fruit to prevent and control.

1. How big a caliber is usually bought by succulent pots

When cultivating succulents, choosing the right Flower pot is conducive to the growth and development of plants. How much does the meat pot usually buy a large caliber?Generally, it is best to buy Flower pots with a diameter of 3 to 5cm than succulents, and it should not be high or too short or too deep. This is not conducive to air circulation or watering.

The Flower pots with Succulent plants are generally selected according to the size of the plant. If the succulent grows quickly, it is similar to that of jade butterfly, aloe, and fairy dance.2 to 3 times large Flower pots, so that watering is also more convenient, and can also help the growth of the root system.

If there are less root systems and slow growth, a small Flower pot should be selected. Generally, the Flower pots are 1-2 cm larger than the diameter of the succulent. Because small Flower pots are not easy to accumulate water, it is also conducive to the breathing effect of the root system., Make the fleshy grow lush, and small Flower pots do not occupy space, and the ornamental is higher.

2. How to choose a succulent pot

At present, there are many Flower pots that can be planted in the market, there are many types, and the materials are different. Therefore, in the process of succulent breeding, everyone must also choose according to different varieties of succulent.

Most fleshy is still cute and small, so they do not like too much containers in themselves. When choosing Flower pots, we should choose Flower pots similar to the overall volume of succulent.

For novices, when choosing a polychide pot, you must choose a hole at the bottom.Because for novices, there is technology with Flower pots. It is very likely that after a period of time, the flesh will be kept to death.The Flower pots with holes at the bottom are very good for succulent growth. It is easier to determine whether there will be water accumulation when watering, and it also has a great effect and benefit for the maintenance of its later root system.

Therefore, if you buy a Flower pot, you buy the bottom without holes at the bottom, you can also find a way to open a hole for the Flower pot. The purpose of this is to increase the breathability of the Flower pot.The breathability is enhanced, so that the fleshy roots can breathe more fresh air.

Golden Kirin's breeding method

1. Breeding soil

Golden Kirin first needs to prepare a soil that is suitable for growth. Generally, Jinqilin is suitable for growing in soil with a loose, breathable drainage. It can be mixed with pond mud, river mud, and cornography according to the ratio of 3: 2: 1., Can make Jin Qilin grow better.

2. Growing environment

In fact, the breeding method and precautions of the golden unicorn need to be placed in a warm and humid environment. Usually, it is best to place the golden Kirin in good ventilation and adequate light.Kirin leaves are dehydrated and withered, and the temperature is controlled above 5 C in winter to prevent frostbite plants from affecting growth.

3. Water Fertilizer management

Jin Qilin likes neutral water. When watering, the water quality cannot appear acidic or alkaline.Watering should not be too much, which is harmful and unhelpful, so there must be no water in the Flower pot of Jinqilin, otherwise the rotten roots, rotten stems and even the entire plant will rot.Jin Qilin can pour water once every 6 to 7 days during the strong growth period, basically to see dry and wet.Watering in summer can be more frequent and poured once a day, but do not pour it through; basically do not dry or pour in winter; pay attention to drainage during the rainy season.Note that the temperature of the watering cannot be too different from the room.Jin Qilin needs to apply some base Fertilizers when planting. During the growth period, it can be fertilized once a month, and some flower Fertilizer can be applied to promote flowering during the flowering period.

4. Method

Golden Kirin generally breeds with eggs. It also has the difference between male and female. Each year, Jin Kirin can produce 50 eggs. Put the golden Kirin egg in water, control the temperature around 20 C, wait for 15-30 to wait 15-30The sky can hatch the golden unicorn, and the general reproductive survival rate is very low.

5. precautions

Golden Qilin needs to turn the basin to change the soil every 1-2 years, otherwise it will gradually wither, and Jin Qilin is not cold-resistant. At a temperature below 5 C, it is easy to frostbite.The temperature is controlled above 5 C to make Jinlin safely overwinter.

What to do if Jin Qilin rotten roots

After Jin Qilin rotten the roots, first remove the plants with soil balls from the pot, cut off the damaged root system, soaked in the 0.1%potassium permanganate solution solution, and dry the pot in the shade.Place it at the bright scattering light to control watering. After the new leaves are germinated, normal management is performed.In addition, after germination, 0.1%perplexed dihydrogen phosphate solution is applied once a week.