precautions for the use of electroplating goggles

1. Do not touch the lens with your fingers, so as not to leave your fingers, or let the oil pollution of the grease on your hands.

2. Because the contact with the eyes in the Swimming goggles is partially closed, and wearing it for a long time can easily lead to hypoxia.Therefore, it is recommended to take the swimming lens for a while each time it is used to allow the eyes to replenish fresh air in time.

3. After each use, wash the mirror with water and dry them in water and place them in the swimming moster box.After using it for a period of time, there may be oil -stained stains on the lens. At this time, it can be rinsed with a neutral liquid detergent and water, and then dried.

4. Do not expose the Swimming goggles in the sun, or put it in high -temperature environments such as car trunk and radiator.Because the anti -fog agent of the swimmingoscopy will be damaged due to high temperature or ultraviolet rays, shortening the anti -fog life.

5. The electroplating goggles itself comes with anti -fog coating, so with alcohol or other organic solvents, it will corrode the swimming mirror of the coating defense Outdoor ultraviolet rays.

Plating Swimming goggles for novice trial wearing

1. Hold the frame of the swimming mirror to make the inside of the lens aimed at the eyes.Put your thumbs on the edge of the frame, the index finger is placed on the upper edge, and the left and right mirror frames are pinched.

2. Pick up the Swimming goggles and buckle the frame on the eyes.Gently hold down the edge of the frame with your fingers.When the goggles are seal around the eyes, you feel that it will have a little suction.

3. Pull your head to your head.Press the goggles with one hand and pull the head strap to the back of the head.From the side, the Swimming goggles and headband should try to be on the same horizontal line as much as possible.

4. Adjust to the most comfortable tightening level.Pulling the headband from the Belt to the outward to tighten the swimming mirror.If you feel a little tight, you can lift your Belt and loosen your head inward.You don't need to pull too tightly, just feel comfortable.

5. When the swimming is finished, let go of the starting band, and then remove the Swimming goggles.The steps of picking goggles are opposite to the wearing goggles.Hold the left and right ends of the head strap with both hands, grab the lower edge of the strap with your thumb, and turn the head strap forward over the head to remove the goggles.

Can the electroplating goggles be used in the indoor swimming pool?

It is not recommended.

1. The electroplating goggles are mainly used for Outdoor swimming, which can prevent strong light and anti -ultraviolet rays.In the indoor swimming pool, the sight will be blurred due to weak light.

2. The surface of the electroplating swimming lens lens adopts a vacuum plating film to prevent UV stimulation of the eyes, especially suitable for beaches and Outdoor swimming.