1. How to tie shoes for hiking shoes

1. Basic system

(1) Aura Shuanghuan Law

Pass the shoelace through the shoe hole, wear the left and right ends through the opposite shoelaces, and then wear the lace on the left and right ends back to their respective shoelaces, and finally tighten them.This method is suitable for most sneakers, mountaineering shoes or casual shoes.

(2) Pilot Law

Similar to the Aura Shuanghuan method, just put on the left and right ends into the shoelaces in turn, and then lead the shoelaces inside the side shoelaces to the other side.Just tighten.This system is suitable for higher tightness, and the upper is required to be more tightly attached to the foot type, and it can also make the feet more stable.

2. Special system method

(1) Magic Pastening

Suitable for hiking shoes with magic stickers, remove the magic paste, closely bind the hind heel and instep with the shoelaces, and press the magic paste tightly, which can achieve a fixed effect.

(2) T -type cross method

Choose a wide and soft shoelaces, pass through the front foot shoe holes, cross the left and right ends, and then pass through the corresponding shoe hole, repeat this action, and finally make the shoelaces.The average distribution of foot pressure provides comfort for long -term travel.

2. precautions for Hiking shoe lace

1. Make sure the heel is stable

After tie the shoelaces, walk around and check whether the height of the heel lifts more than 1/4 inches (about 6 mm).The heel stability can reduce the blisters caused by friction, and avoid sliding the entire foot when it goes downhill.

2. Provide support but avoid stress

hiking shoes should provide comfortable support in the most needed place, including the inner side of the feet.Appropriate support can avoid fatigue and injury to the feet, but it should not be too tight to cause unnecessary pressure.

3. Leave the stretching space

A stretching space should be left in the foot tip area, so that the toes can be opened, moved, and ensure the stability of the whole body.This is also the key to avoiding the so bluff of the toes.

4. Adapt to different foot types

Different shoelaces can adapt to different foot types, such as tall back, low -back or narrow feet.Use "locking" technique to prevent the shoe lace from sliding and keep your feet stable.

5. Adjust the length of the lace

Adjust the length of the lace according to the type of shoes and the needs of Hiking.The flat shoelaces are usually less prone to loosen than round shoelaces.

6. Tightened laces to prevent damage

When Hiking with random stones and branches, we should tighten the shoelaces to prevent the tongue from top to the ankle, thereby blocking the branches and stones that may hurt your branches.

7. Check and adjust the shoelaces

During the travel process, check whether the lace is loose or worn regularly and adjust it as needed.If the laces are loosened, stop immediately and re -tie it to avoid increasing the burden of walking and the risk of falling.

[Online shoes maintenance] How to clean the net shoes how to brush the net shoes, how to make up for the net shoes

How to clean the surface sports shoes?

How to wash net eye sneakers?sneakersIt is the most common and popular sports shoes.But no matter what shoes, if it is not clean, it will always feel like that.So keeping the shoes clean is the key.But no matter what shoes, you still have to wash it.For example, how to clean the surface sneakers? If the surface shoes are cleaned, it is very convenient to clean it.But be sure to pay attention to one, do not use a plastic brush to brush the surface of the net surface.Because it is used to use a plastic brush, the surface of the mesh will be easily brushed out of the ball and hairy.

As long as you don't need this, how to clean the surface sneakers is really simple.Whether you are washing machines to clean or wash it by hand, it can be said that it is not limited.You can use laundry powder to clean it, or use detergent to clean.Even a few pairs of shoes can be placed in the washing machine together.Because the shoes on the mesh surface are good and are not afraid of stirring.No matter how you wash it.The question of how to wash net sneakers is really not necessary.

However, if it is white or to make the shoe life longer, then you still need to pay more attention.For example, do not use a washing machine when washing.When using a brush, work hard according to different places.Pay attention to maintenance shoes.How can I have so many questions on the question of how to wash the sneakers on the eye?In other words, the sneakers are the best sneakers in the sneakers.And when you wear it, you are the most comfortable, especially in the summer, almost everyone will have a pair of sneakers with mesh eyes.In short, as long as you do not use a hard brush to brush, you can wash it.

How to repair the sneakers?

First of all, if you are purchased in the prescribed regulations, generally within the three packs, you can go to the merchant for free repair. If it is because of the quality of the product itself, it can be repaired for free. If it is because you are personalAs a result, the cost is required.What should I do if I have broken the sports shoe net? If it has passed the three -pack period, you can only take it for yourself or buy a new pair of shoes.

When the shoes have passed three packs, you must find another way.How to repair the sneakers on the mesh? If the mesh is not very large, it is just a slight hair. You can handle it. First, you can cut it with a small scissors.The hair part will be retracted.However, if the hole breaks is relatively large, it will be difficult to see or not handle it if you deal with it yourself. You can get a professional shoes beauty shop sneakers network shoes.It is a professional material and tools and technicians that can be repaired. When repairing, the correct fabric and formation will be selected according to the fabric and characteristics of the shoes.

What should I do if the sports shoes net is broken?

If the sneaker net is broken, it is not the problem of its own quality. Generally, it is a place where the tip is hooked, causing the net to break.How to repair the sneakers? If you can go directly to the merchant to repair it in the three -pack period, you can repair it and continue to wear it. This will not be repaired.However, if the hole is too large or after repair, it will affect the beauty, it is recommended to buy another pair.

1. What does ice hockey shoes mean?

After buying icehouse shoes, it usually needs to be blank. Many friends may not know what the blade means. In fact, the blade of ice hockey shoe refers to the first time the blade was grinded after buying the icehouse shoes.Stick the defects on the blade, form a sharp blade, and grind the inner and outer blades.

2. Is Ice Hockey's Blade?

need.

If the newly bought icehouse shoes, if the ice knife does not slide directly, the blade is "round" for a while (that is, it cannot be a right angle, with the arc), and then the blade is easy to open the knife (the left and right feet are intensive.Different, the degree of roundness is not the same, and then the blade is easy to open high and low feet). How expensive the Tube is, the new knife is required.

In addition, after the blade, it is not once and for all. If it is grinded for a while, it occurs that the ice is unstable and slippery, which means that the ice knife is needed to grind the knife.

3. What is the difference between ice hockey shoes and unspoken blade

Ice coat shoes are ice -knife shoes worn during ice hockey. They are the same as skating knife shoes and figure skating shoes. After buying, they need to make blades. Blade ice coal shoes and unshakable icehouse shoes are completely different.The differences between them are:

1. Different functional differences: Blade ice knife can skate. The ice knife without blade cannot skate and it is easy to fall.

2. Different effects: The blade of the ice knife can be strenuous on the ice, and the ice knife that is not blade is more blunt and cannot be worked hard.

3. Different appearance: The blade of the ice knife is more shiny and Smooth, and the ice knife that is not blade is relatively dull and dim.

Mooth classification of Sunglasses lenses

1. glass lens

The glass lenses are often exposed to it. The most prominent advantage of glass lenses is that its optical properties are very stable. This is the usual advantage of glass lenses. It is the same on frame glasses.Affected by the pressure of the framework.The disadvantage of glass lenses is that it is easy to break, and it is easy to cause damage to the eyes.At present, the newly developed enhanced glass lenses are more prominent than ordinary glass lenses, and they are also considered a safe lens.

2. Polarized lens

This is a lens used on polarized Sunglasses. The polarization principle of light is used. In the future, the glare obstruction of the parties will be separated from the lens to make the sight clearer and safer when driving.In 1937, Dr. Edwinland in the United States invented this lens and was widely used in polarizing Sunglasses, and he also created his own Pokmon company.

3, color change lens

Also known as sensitive lens, due to the change of light, the color of the lens changes accordingly, so that the eyes can adapt to different environments. Under the strong light, the color of the color changing lens will deepen.EssenceThis kind of lens has been used in myopia Sunglasses. This kind of Sunglasses in the form of color -changing lenses are also considered to be the most convenient and most beautiful myopia Sunglasses, which is more popular than clamping.

4. Plastic lenses

This is the material that many Sunglasses brands like very much. Light and not fragmented are its most obvious features. The functions of non -processed plastic lenses are significantly better than glass lenses.EssenceThe disadvantage of plastic lenses is that its wear resistance is easier to scratch. When the lens is impacted, it is also easy to deform, so it should be more careful about its maintenance.

There are three main types of plastic lenses, namely resin lenses, PC lenses, and acrylic lenses.

5. Resin material Sunglasses lens

Friends who often wear glasses must have heard of resin lenses, but what are the resin lenses?Resin (CR-39) is actually a chemical substance of the phenolic structure. It is refined from the phenolic components in oil. The characteristics are light weight, high temperature resistance, strong impact resistance, and can effectively block ultraviolet rays.The great advantage of resin lenses in Sunglasses is that it is easy to color. Many fashionable Sunglasses use resin lenses to favors the characteristics of coloring.But the resin lenses are poor and impact.This type of Sunglasses have a wide range of use and strong decorative effects. It is a good choice for fashion people.

6. PC material Sunglasses lens

PC refers to polycarbonate, a type of plastic (PC). It is a polymer polymer containing carbonate groups in the molecular chain and PC material. In short, it is a Sunglasses material material.There are high -end points, PC films commonly used by professional athletes and colorless or colorless plastic sheets.It is characterized by lightness and good coloring performance. The disadvantage is that the abrasion resistance is low and the optical properties are unstable.PC -made Sunglasses are more suitable for sports people and drivers.

7. AC film (acrylic lens)

It has excellent and tough characteristics, has a high perspective rate, has good anti -mist resistance, the lowest cost, the material is crispy, the rupture may have crumbs, and the stability of optical indicators is average.

8. nylon material Sunglasses lens

nylon Sunglasses are used in sports brands Sunglasses and high -quality big -name Sunglasses. It has high elasticity and excellent optical quality, and has a strong resistance to impact.Professional protection function.However, nylon lenses have poor wear resistance and high production costs.Such Sunglasses are more suitable for people for sports or professional protective mirrors.

9. Tac material Sunglasses lens

TAC Sunglasses are relatively widely practical in China. TAC (triax cellulose, TriaceTyl Cellulose), which is complicated, is one of the high molecular materials with high penetration.TAC has the characteristics of Sunglasses, which has the characteristics of acid -resistant type, light texture, and high cost performance.However, the abrasion resistance has become a soft foot of TAC lenses, and it has its less stable optical characteristics. Although the price of TAC lenses is low in price, it is eventually discarded by most well -known foreign brands.

Disclaimer: The above content is derived from the provision of the program system index or the sharing of netizens. It is for your reference only and does not represent the research perspective of this website. Please pay attention to the authenticity and authority of the source of the content of the content.Apply to delete & gt; & gt;Correction & gt; & gt;