How to install an electric car sunshade

1. Prepare a wrench in advance to confirm that the electric vehicle sunshade shed is complete and non -damaged, and the accessories are not omitted.

2. Understand the hexagonal screws of the rearview mirror with a wrench, remove the two rearview mirrors, place the connecting rod of the sunshade between the rearview mirror and the electric car body, and twist the rearview mirror.

3. Insert the two sleeves in the front of the sunshade into the connector, be sure to insert it to the end, so it is very tight.

4. Pull the back of the sunshade to the rear box of the electric vehicle, and tie them on the electric car body on both sides with ropes. If you want the position of the ripkin, you can also tie it to the back of the rear box.

5. At this time, there are four elastic rods in the remaining accessories. The two thicker and rigid ones are reinforced on the top of the shed, which are connected respectively.

6. The other two long and soft elastic rods are supported by the side of the rails, which are connected separately to complete the installation.

What should I pay attention to when installing an electric vehicle sunshade

1. Be sure to reserve the expansion space, the screw spacing, which can be made according to the thickness of the board. It is too small and too large.If the spacing is too small, sometimes it will cause stress due to too tightly, causing damage; if the spacing is too large, the PC board may not be unstable.

2. The plasticizer in the PVC cushion and the chemicals in certain rubber pads will be migrated to the surface of the cushion. After contacting the PC board, the PC board will be destroyed, so it is absolutely not available.It is recommended to use the material of the cushion, the product of the Sanyangi Copycopar, silicone rubber and chlorine rubber.If there is no suitable padding, it is better not to use it, nor can it be used to destroy the pad of PC.

3. In addition to the waterproofing, the double -sided waterproof tape can also be used for the pad material between the PC board and the frame.Some double -sided tapes are damaged in the face of PC boards, so they are also selected during installation.

4. PC boards are very easy to scratch. Do not tear the protective film when installing.Before cutting, the marker must be marked and marked as much as possible on the protective film. If it must be marked directly on the plate, please use a crayon to avoid using sharp tools to contact.