Emperor Flower's Breeding Method and Precautions Emperor Flower Planting Method

1. The breeding method and precautions of the emperor flower

1. Soil The planting soil of the emperor flower requires good drainage performance, especially the seedlings.If the pot is tied, the seedlings are difficult to grow.The sandy soil is the most suitable for the growth of the emperor.In family breeding, Flower pots should also choose a slightly larger breathability pottery pot.

2. Temperature The temperature of the emperor's flowers is generally not less than 7 degrees Celsius, and the temperature in summer should be 27 degrees Celsius.Individual varieties can resist low temperature, and zero -degrees Celsius will not frostbite.

3. Light The emperor's flowers like the sun.It can be maintained at all sun.But in the summer, it needs to be cool and dry, and it needs to be appropriately shaded in the scorching sun.

4. Watering The emperor flower likes to dry the environment. Watering can be appropriate, and there is no need to keep the pot soil moist.However, pay attention to the adjustment of the humidity of the air to spray water mist around the plant.

5. Fertilization The emperor flowers are not very high in nutrients. Each Fertilizer can meet the growth requirements once each spring and autumn.

2. How to plant the emperor flowers

1. planting time First of all, you need to choose the appropriate time. The emperor's sowing time is more about the autumn October. At this time, the seeds are just picked, and the germination power is relatively strong.And at this time, the temperature and humidity are more suitable, and the seed germination rate can be increased after planting.

2. seed treatment The seeds of the emperor flowers are difficult to pick them. The petals need to be placed in the sun and dried, and then picked the mature seeds with their hands.After that, you can soak in warm water for 3 to 5 hours, and you can remove it and use high -lipid film for planting to avoid the breeding of bacteria.

3. Soil preparation The emperor flower likes to grow in the soil with strong breathability and good drainage, so you can choose to prepare humus soil and river sand according to a 1: 1 ratio.You can add an appropriate amount of rot bark and base Fertilizer to give the seeds enough nutrients, which will shorten the time for seed germination.

4. Sowing and maintenance Place the seeds of the emperor flower in the soil, covering 3 cm thick soil, and sowing about 3 seeds in a Flower pot.After the sowing is completed, watering is required. There is no need to water again during germination. When the emperor flowers grow out of the real leaves, you can water the second water and move into the astigmatism environment.

3. How to cut the emperor flowers

1. Choose the branches above the semi -wooden position of the emperor Hua Mother.

2. The matrix uses peat and perlite to mix with a volume ratio of 4: 6, adjust the pH value of 5.5 ~ 6.5, and the EC value is less than 0.5.

3. Immerse the cutting base of the cuttic acid solution of 1000 ppm, soak it for 15 minutes and air dry immediately.

4. The depth of cutting is 1/3 ~ 1/4 of the length of the cuttings.After cutting, manages according to conventional technology, and field transplant is transplanted after the seedlings are out of seedlings.