How to adjust the length of the mountaineering stick for the mountaineering stick

1. How to choose the length of the Climbing stick

When buying a Mountaineering stick, people will have a question, how should the length of the Climbing stick choose?How long is the Climbing stick appropriate?Generally speaking, climbing sticks can be divided into three different lengths: 135cm (standard stick), 125cm (lady's stick), 115cm (children's stick/old stick).

A donkey friends with a height of more than 1.7 meters suggest to choose a 135cm Mountaineering stick in order to deal with complex road conditions such as steep slopes; donkeys with a height of below 1.7 meters can choose a 125cm Mountaineering stick.However, the Climbing stick can generally adjust the length, and it can be adjusted by the telescopic and locking device.

2. How to adjust the length of the Climbing stick

The selection of mountaineering rods is also very particular about adjustment; adjusting the length of the climbing according to the body and terrain to make the Climbing stick produce the best results.When adjusting, you need to rotate all the locked parts on the stick, and then adjust the scale on the rod.

There are two types of adjustment: one is to stand on the flat ground to support the elbow of the arm of a Hiking rod, and naturally down the arm, bend the arm right angle, and then start adjusting the height of the Climbing stick until the tip of its rod tip of the rod tip.Just touch the ground; the other way is to make the handle at 5-8 cm under the armpit, and then start adjusting the rod until the tip of the stick is just touched on the ground.After the height is adjusted, lock all rotating parts.Note that when adjusting, you should always pay attention to the scale on the rod, and the length must not exceed the limit height marked on the rod.

When adjusting the three -quarter, the Mountaineering stick, in order to keep its strength in the best state, try to make the three sections as long as possible.Only the adjustment of one or two sections is incorrect, which will make the strength of each section of the rod uneven, and it is likely to cause the rod deformation for a long time.In addition, no matter which rod is, it cannot make it height exceeding the limit scale.It is recommended that when regulating, you can first adjust the two sections in the three sections to the same length, and then adjust the third section appropriately.