How to install the outdoor lighting method outdoors outdoor shot lamp

Outdoor fire lamp installation step

1 Pencil positioning

2 , Electric Hammer Open the hole, hit the expansion screw

3 , Upper base, pull into the wires, fix the screw

4 , Wiring head, installing the lighting light part

Outdoor fire lamp Pay attention

1 As well as Note that the position of the line is well -arranged, and the electrician needs to be cooperated with the carpenter.

2 When opening the holes, try to turn on the circle as much as possible. If you turn on the light, it will not look good.

3 , Consider what kind of fire Lights are used before the Outdoor door signboard installation.

4 , After connecting the driver line, the two ear cards of the Lights can be entered into the ceiling hole.

5 As well as When installing on the board, you must bring gloves. If you accidentally leave your fingerprint or stain, you can use the detergent to clean it and dry it. It is easy to disassemble the good installation process.

Light installation method

accessories:

lighting rack, lamp installation and connection lead to the lower line test lamp

Process process:

1 2. Terrate lamps according to design requirements (( Lamp rack Cure installation height, mark on the electric pole.

2 , Hang the light rack and lamp on the electric pole (( The heavier lamps and lamps can be hung up with a pulley and a large rope. Cure , Put on a hug or bolt, find the angle of irradiation according to the design requirements. After finding a good level, fix the light rack.

3 The rows of lamps should be consistent and neatly arranged.

Concope the line:

Fix the needle -type insulator on the lamp rack, tie one end of the wire on the insulator, and connect to the lamp head wire and the fuse, respectively.The rubber cloth and vinyl cloth overlap each other.Then tighten the other end of the wire and wrap the wrap connection with the back buckle of the street light.