How to install the suction shelf to suck the suction shelf

What should I do if I can't suck the suction shelf

1. Dip water

The main reason that causes the suction shelf is often on the plane. When there is dust on the wall or mirror surface, it will cause air leakage to the inside of the suction cup.Impurities exist.At this time, you can dip it in water, or use hot water to soften the suction cup and stick it. Remember to slowly press out from the middle to the surroundings to drive out the air, but be careful not to blame the suction cup and deform.

2. Put the egg white

Separate the egg white in the egg from the egg yolk and apply the egg white to the inside of the suction cup with a cotton swab. Remember to be uniform, and only a thin layer is enough.After going up, the egg white is completely killed. It takes almost 12 hours to work. At this time, the suction cup is firmly fixed on the wall, and it will not fall off anymore.The principle is that the egg white contains glue, which can help the suction cups better adhesive and the contact surface, and the glue fills the gap and squeeze the air, so the suction cup will firmly suck on the wall.

3.

Use toothpaste to replace the egg white can also have the same effect. Squeeze out an appropriate amount of toothpaste and apply it on the back of the suction cup, and then stick to the corresponding position. When the toothpaste is almost combined with the hookThe effect of water and soapy water is much better.

4. Wipe it with alcohol

A large part of the suction cup folded is that the position of the paste is not handled clean. Wipe it with alcohol and remove the dust, so that the paste will be firm.

How to install the suction shelf

1. It is best to install the wall with a Smooth plane;

2. Dry the wall with a dry cloth;

3. Press the suction cup to the wall from the middle to the surroundings;

4. Then wait for a while before use.

How to remove the suction shelf

1. If the glue is hard (such as AB glue), it can be heated with a hair dryer with a hot air. After softening, use the knife to remove it.

2. If the glue is soft, cut it directly with the artist knife.

3. If the glue is relatively thin and there is no thickness, you can use the fish wire to be removed. Use a wet rag (rough) to add a cleaning agent a few more times.