Special Mic How to put away the tent of the road tent
How to put it in the Tent
How to close the automatic Tent
(1 ) Put your hands on the head of the Tent pole, on the two branches, force the middle to the middle, and close the two Tent rods.
(2 ) Holders with both hands slightly, pressing the head down.Note here that when storing, it is best to open the door of the side to discharge the air inside.
(3 ) Fold the four corners of the Tent.When the folding lever, gently pull it out, and then fold.Note: Because there are locks at the joints, if it is folded hard, it is likely to damage the ledger.
(4 ) After folding the four corners, lie flat on the ground, roll up the book, the size of the Tent is out of the Tent, and then tie it to the rope.Remember to take it slowly so that the gas in the Tent can be completely discharged.Finally, put it in a storage bag.Why do you choose to use rolls instead of folding and folding?Because the folding will be greatly damaged to the coating, it is recommended to choose a roll instead of folding the Tent.
(1 ) First check the four corners of the folding Tent stent, whether there is abnormalities.Note that the four spring buckles on the corner, the spring buckle of the supporting Tent should be buckled in the eyes of the Square Tube, and the Square Tube eyes can be moved up and down.
(2 ) spring buckle is unlocked from the eyes of the Square Tube.All the spring buckles of the four corners are unlocked.All the items in the folding Tent are emptied.
(3 ) Two people stand relative, holding two brackets of the folding Tent with both hands.It should be noted that the two should stand at the vertical folding of the canopy bracket to ensure that when they are hard, the top canal can be folded up.
(4 ) The two push the bracket together in the direction of the other side, so that the top of the canopy bracket is folded.
(5 ) Fold to fold 70% When, you can flatten the folding Tent on the ground.Pay attention to the ground clean, do not stain the Tent.
(6 ) Unveil the four corners of the tarpaulin.The four corners of the tarpaulin are on the four corners of the canopy, and the magic stickers are tightly sticked to unveil the magic sticker.
(7 ) Take the canopy bracket and collect the four bearing brackets and push the internal pipes.
Pathfinder Tent installation method
*Umbrella Tent installation steps
Just install it according to the instructions.
Other road detectors Tent installation methods: First, lay the Tent front on the ground.Secondly, put the support rod on the paved Tent.Finally, the buckle on the Tent is evenly stuck on the support rod, which is the installation method of the buckle Tent.
If there is no buckle, you can go through, and there will be perforation on the corner of the Tent, and you can put the support rod in.Put the end of the support rod on the fixed buckle on the four corners of the Tent.Tie the two support rods at the top (the top is designed with a rope).If you need to insert the attached fixed rivet link Tent around. Pathfinder Tent products & gt; & gt;