How to use solar lamps to install solar lamps

1. How to use Solar lamps

According to the principle of Solar lamps, Solar lamps are powered on during the day and light at night.The specific Solar Lamp working principle is simple. For Solar cells made of photocopyral effect principle, Solar panels during the day receive Solar radiation energy and convert them into electrical energy output. The charging controller is stored in the battery.The left and right, the voltage of the opening of the Solar cell board is about 4.5V. The charging controller detects the voltage value after the voltage value is detected, and the battery discharges the lamp head.After the battery is discharged for 8.5h, the charging and discharge control action is over, and the battery discharge is over.The main function of the charging controller is to protect the battery.

2. How to install Solar lamps

So how to install Solar lights by yourself?The method of installing Solar lamps is very simple. Just choose the right position and install it directly. The specific steps are as follows:

1. First choose Solar silicon boards.Select the size of the Solar panel according to the area or brightness requirements.

2. Then configure Solar lamps.Generally, it is better to choose LED lights. It uses low voltage, small current, and good light emitting effect.Compared with energy saving.It is recommended to choose a Solar Lamp with a special battery.

3. In terms of installation, the Solar panel is installed outdoors, and the sunlight should be received.The time to install the sunlight also determines the effect of the Lights.

4. When installing Solar panels, pay attention to waterproof, and try to install it at a high place, so that rainwater should not be soaked.

5. Share a small tip here is to place a thin transparent ordinary glass on the Solar board.This prevents the rain from getting wet directly and can effectively block the sun.Extend the service life of Solar panels.