How to use the bicycle code how to install the bicycle table

1. How to use the Bicycle code watch

The working principle of the bicycle sheet is that the sensor captures the information brought by the inductive magnet when the car rotation is rotated. The sensor code is transmitted to the code watch.

Function display

1. Automatically display.Press the function button (the big button below the code watch), and only the word AUTO appears. At this time, the code watch automatically displays the riding distance, time, total mileage and clock with a interval of 1 second.

2. Manually display.Press the function button, the word KM appears, indicating that the travel distance is displayed at this time;

Press the function button to appear alarm clock pattern, indicating that the travel time is displayed at this time, and the accurate display of the second;

Press the function button, and the word appears, indicating that the cumulative cycling distance that starts with the code watch at this time is displayed.

3. The code watch is clear.Pressing the function button is not less than 3 seconds. At this time, the numbers on the code flickering are flickering. Continue to hold it until the clear is cleared. The clear zero does not affect the cumulative riding distance.

Use setting

This function determines the correct use of the code watch, which is very important.The main function is to enter the car wheels, adjust the clock, change the speed unit, and turn on the automatic display function.

Enter the setting interface.Press the setting button on the back of the code watch for 3 seconds, and set the word, that is, enter the settings interface. At this time, the four -digit number displayed below is the wheel length. At this time, press the function button to enter the next function settings interface.

Exit the setting interface.Press the settings key for 3 seconds to return to the use state.

2. How to install the Bicycle code watch

1. Install the base of the code watch.

First install the base of the code watch. The back of the base has foam glue. Tore off the yellow plastic surface, you can stick it on the handlebar, and then use a rubber band to walk around a circle, stuck in the card slot on both sides of the base.The bottom of the code is firmly fixed on the handlebar.

2. Next installation header.

The inductive line is wrapped around the brake wire, until you need to install the position of the sensor, the sensor can be installed in the middle of the axle and the brake in the front of the front rod.

The installation method is similar to the installation base. After selecting the position of the sensor, press it with your fingers, and then use a large rubber band to circulate around the car, and buckle the rubber band into the card slot of the sensor.

3. Instant induction magnets.

The induction magnet needs to be installed on the steel wire banner of the tire, which can be facing the position of the sensor.After the soft magnet is put on the steel wire, the iron rings in the installation bag are stuck from the bottom to the groove of the magnet from the bottom to the groove.This is the best induction effect.

After this code is installed, the next time the wheels are adjusted, so the data read is accurate.

4. Setting perimeter parameters of bicycle codes

How to set the wheel diameter of the bicycle codes?Put the code watch with an angle of 45 degrees on the base, press it slightly, and rotate it counterclockwise.Then look for a straight line on the road. Generally there are cement floor. People ride on the car and adjust the nearest position of the valve core of the tire to keep the nearest position on the ground.The distance between the measurement is the perimeter of the wheel, so the measurement is more accurate than the reference value of the tire on the instruction manual, because when the person is riding on it, the tire pressure will change.The value is fine.Specific settings can be adjusted to the WHEEL SIZE menu and fill in the preset value.

Kind tips:The setting of the Bicycle code watch needs to be set according to the purchased code table brand, as well as models (such as mountain vehicles, road cars, and station wagons). Different brands have different models with different code table settings.Different brands and different installation details. Different models generally need to understand when debugging the code table data.Therefore, carefully read the manual before installing the bicycle codes.