Japanese red maple cutting time and method Japanese red maple breeding method and precautions

1. cutting technology of Japanese red maple

1. Cutting time

The time of red maple and tender branches should be selected in summer and autumn, that is, from June-September, it can be available.

2. Cutting cuttings

The selection of red maple cutting is recommended to choose a half-wood rough branches with a diameter of 0.5-1 cm. The length of each section is about 10 cm. The upper end of the branches is retained with 3-4 leaves.The leaves are cut off 1/3, so that water evaporation can be reduced as much as possible.The cutting base should be cut into a 45 -degree section, and then put it into a moderate rooted water for half an hour to speed up the rooting speed of cutting after cutting, shorten the rooting time, and increase the root rate.

3. Cutting process

After the cuttings are treated, insert it into the peat soil or vermiculite, and then place it in the shade of it and do it.If it goes well, it can be transplanted at a maximum of 1 and a half months, and the survival rate is about 80 %.

Second, Japanese red maple breeding method

1. Humidity control

After the cuttings are completed, they will be poured once immediately. This will not only make the cutting base of the cuttings closely in contact with the soil, but also increase the humidity of the soil.After that, the amount of watering should not be too large, and water accumulation should be avoided, otherwise it is easy to cause corruption and death at the base of the cuttings.Under normal circumstances, spray water 2-3 times a day, and can be increased to 3-4 times under high temperature conditions.

2. Cooling treatment

If the temperature is too high, it will affect the growth of the plant and even burn the seedlings, so it is necessary to take a good shades to avoid direct light.At the same time, in order to achieve the cooling effect, it can increase ventilation and combine the method of water spraying to achieve the purpose of cooling.

3. Adjust the light

Because the insertion is still very fragile, the light cannot be strong, otherwise it is easy to burn the branches due to high temperature.Therefore, we need to use the Shading net for the Shading of the branches, which can reduce the strength of the light; the family potted plants can be placed in the sun in the early morning and dusk in the sun to receive the light.When the young plant is rooted and stable, the light time and strength can be appropriately increased every day.

4. Breeding soil

Japanese red maple is suitable for grown in loose and breathable and slightly acidic soil. It can choose humus soil rich in humus and well drainage for breeding.We can also apply a certain amount of base Fertilizer in the soil, which can increase the fertility of the soil.

5. Pruning management

During the process of breeding the Japanese red maple, the plants need to be trimmed regularly.Before trimming, you need to use alcohol cotton cloth to wipe and disinfect the trimming Tool, and then cut off the plant that grows over or too densely. After trimming, you can apply plants on the wound.

3. precautions for Japanese red maple breeding

When we cultivate Japanese red maple in winter, if the ambient temperature is lower than 10 C, the plant will be frostbite, which will affect the normal growth of the Japanese red maple.Therefore, when the temperature is relatively low, you need to keep warm for the plant. You can use a grass cushion or cotton cloth to wrap the plant.At the same time, it is necessary to stop watering or fertilizing, so as to make the Japanese red maple spend the winter smoothly.