[Production of folding bed] How to make the folding bed on the wall of the folding bed

[Production of folding bed] How to make the folding bed on the wall of the folding bed

For those who go to school or work in the metropolis, the most distressed is the small space for living.Especially in the first -tier cities, not only the rents are expensive, but the room space rented is very small, and there is no place to put Xi Mengsi in a row.Therefore, today I shared the production of this folding bed. When you need to use it, you can just turn down the bedboard. It is quite convenient to lift and lean on the wall when not in use.

How to make a folding bed on the wall

1. Main materials

Founded wood, wooden board, hand saw, hammer, wood screw, coarse sandpaper, pencil, etc.

2. Production steps

Today, the tutorial is the production of folding single beds. The size is based on the actual situation of your own. The conventional size is 80*180, 80*190 and 90*200cm. Generally, you can customize your appropriate size.EssenceHere we designed 80*180cm, with a bed height of 30cm.So how to make a folding bed?It is not difficult for a carpentry enthusiast or a carpenter. Let's take a closer look at the production method.

1. Nail -made bed frame

First cut the two Square woods of two and two 180cm with a hand saw, and use a wooden screw (or iron nail) to nail a 80*180cm folding bed framework.Then the 2.5cm position on the inside of the frame is added with a 75cm horizontal crotch (pictured), and a 165cm vertical gear is added in the middle.Finally, a few bedboards are nailed, so the simple frame of the bed is done first.

2. Make bed and feet

The height of the bed is about 28cm, which can be adjusted according to your needs.Four beds, which are divided into two inner beds and two outer bed feet.First of all, we make the inner bed feet, first saw two Square wood materials of 2.5*7cm in length of 26.5cm, and then insert one end into the middle of the two horizontal crotch under the bedside.swing.Then nail a 1.5cm wooden board on the lower end of the bed to play a role in a natural fixed inner bed.

Then start making the outer bed foot, and first saw the two 2.5*7cm Square wooden materials with two 28cm length, insert one end into the crotch gap of the bedside head, and then fix it with a screw.Finally, add a piece of wooden blocks on the outside of the outer bed (pictured). When used, hold the wooden block freely and start the folding bed.

3. Debugging the bed

After the frame of the folding bed is made, you can start adjusting the details, put the folding bed in the specified position, first adjust the four beds to open up and down, and whether the size of the placement position is appropriate.Let all activity components be opened freely, so that even children can put away or put down the folding bed without worrying about holding hands.

4. Laying the bedboard

The bedboard is paved with 1.5cm thick wooden boards. First, the remaining gap is paved with wooden boards. You can use wood screws or small iron nails to fix the crotch of the bed.The paved bedboard should be flat and tight. After paving the bedboard, it should be polished with coarse sandpaper. Of course, it is best to use a polishing machine, so that the efficiency will be improved a lot.

5. Complete

Of course, today's DIY folding bed is also suitable for many small units. It can be made more exquisitely in the production and selection of materials.In fact, as long as you are willing to move your brain, you can improve the spatial utilization rate.