Teach you how to care for the open -air vine compilation table and chair outdoor vine art furniture how to care

1. How to care for Outdoor rattan furniture

rattan furniture is not very common in the family. It is usually used for Outdoor open -air occasions. Vine art furniture that has been outdoors for a long time is easy to dirty and aging.Essence

1. Avoid direct sunlight

The ultraviolet rays in the sun will make the rattan degeneration. The long -term sunlight will make the white rattan furniture yellowed, the brown -red -redtto furniture fades locally, and the expensive bamboo rattan furniture is dry, loose and removed.Therefore, it is important to avoid direct sunlight.

2. Stay away from fire source and heat source

Because rattan furniture is afraid of high temperature, do not make it contact and close to fire sources, heat sources, such as electric iron, hot water cups, etc. When using and storage, try not to put it directly on it.Otherwise, it is also easy to deform, bend, crack, loosen, or take off.

3. Avoid moisture deformation

Tendon furniture is adsorbed by the amount of water, which will be soft and deforming, so it must be prevented from moisture when using it on weekdays.If it is fixed to the original shape after the moisture deformation, it will still return to the original shape and size after blowing or dryness.If the Outdoor rattan furniture is accidentally wet, it should be air -dried as soon as possible.

4. Keep ventilation

If the Outdoor vine -edited furniture accidentally affected the moisture, in the days with the sun, it is best to clean the furniture and move it to a place with a church.

5. Usually do more clean

Generally speaking, rattan furniture is best to take care of it every two or three months. When cleaning, you can use a vacuum cleaner or chicken feathers. In addition, some subtle places and gaps can be used to use toothbrushes, wicker bars, etc.The thin hard hairs are removed to remove the storage dirt in the gap.Finally, clean it with a soft cloth, so that the cleaning work of rattan furniture will be easily done.

6. Anti -insects

When there are signs of insects in the vine furniture, you can kill insects and moth with Pepper or Pepper noodles, and there is no damage to the rattan ware.Specific method: Frying and graduating from half two flowers and half of the salt with half two fine salt, stuffed it into the holes, and then tighten the gross surface with a plastic cloth or small plastic bag to make the smell leak.The same way of using pointed Pepper noodles.After 24 hours of closed pest killing, unlock the plastic cloth, and use the boiling water to push the surface locally, and kill the residual worm.Finally, dry with a soft towel to prevent the insects from spreading.

7. storage and use

When storing, try to place it in a flat place on the ground to let the four legs of rattan furniture calmly and smoothly. If the furniture is often shaken if placed on the ground, it will affect the service life.

Second, the repair of rattan furniture

The "rubbing noodles" method can be used for the rolled and damaged paint parts: the rolled part can be used, and the liquid scrubbing agent can be used, and the scrubbing time is long enough, so the brush should be dragged on it.But it cannot be scraped on the surface like painting wooden furniture. It must be tilted and scrubbing above the tight part of the woven part.This is to allow the remaining liquid to flow to a relatively loose part and not accumulate on a tight -woven part.After handling it, air dry.

The next step is to paint again: the paint is best to use the spraying method, so that all the corners of the corners can be used to the paint.Pay attention to prevent polyurethane from being solidified into a layer of plastic, because it is very hard and brittle, which may cause cracks to all bend parts.

There are also primary renovation treatment methods: clean and repair first, and then air dry.After everything is done, you can use sandpaper to polish its outer rattan again, so that the epidermis is completely decontaminated and returned to Smooth, and finally the optical oil is protected.