What are the common faults of mountaineering rods, how to repair the climbing rod?

1. What are the common faults of mountaineering sticks

1. Stuck and lock: The most common reason is because the operation is wrong, such as the lock is too tight or too loose during use.

2. cycling rods: It is usually caused by errors for the force point, which is usually the one that changes the badly.

3. Polar tip wear: After using it for too long, it becomes Smooth and the anti -slip effect will become worse. At this time, it is recommended to change the tip of the stick.

4. Metal oxidation: When you go home, you do nt wipe or dry immediately, it will easily lead to oxidation. At this time, the Climbing stick will be stuck.

2. How to repair the Climbing stick

1. What should I do if the Climbing stick is rust and oxidize

When maintaining a Mountaineering stick, you can use a very small amount of rust removal to treat the rust on the surface, but before use, you must remove all the oil on the surface so that it will not affect the adjustment of the Mountaineering stick.In addition, you can also use very fine scrub paper to remove rust on the surface, and keep the lock function of the climbing rod is not affected.[Although this may wear out the indication scale above the Climbing stick] Using the rotating lock -locked Mountaineering stick may fall due to the rust rust of powder, blocking the locking rings to affect the locking effect, so when maintenanceIt is necessary to remove the rust of the rings, especially before using them to use them, be sure that the inside is very clean and does not contain any rust and oil.

2. The Climbing stick is not tight and stuck

There are two common locking methods for climbing rods:

outer buckle: The fast -bucking rod is not tight because the snail is loose. When it is loose, the spacing of its clip will become larger and it will not be able to hold its next section.

[Solution] Take a Swiss knife or screw up, and lock it a little bit when you hold it, and the snail teeth will become tight.

There are two kinds of materials for common climbing sticks: plastic fast buckle, aluminum alloy fast buckle.The plastic fast buckle is slightly locked with the screws, and then test whether the looseness is appropriate.The fast buckle of aluminum alloy is sometimes difficult to lock. At this time, you can lubricate oil on the turning point.

Internal lock type: The suspended Mountaineering stick is not tight or stuck, it may be that the expansion clip in the middle is stuck, or the expansion clip runs too much.The length is often adjusted, and the Mountaineering stick is transferred too many times).

[Solution] First remove the expansion, and then reinstall it. The most important thing is that the teeth must be aligned, and then put it back.The expansion clip runs too much or is not aligned, at this time, you can pull it down and install it again.The expansion clip is not aligned, just pull it out and adjust it, then put it back.

3. How to avoid the Climbing stick on the way to climbing

It is recommended to check the locking part before departure and whether the Climbing stick structure is normal.However, if you are unfortunately broken on the way, it is recommended to keep the climbing rod completely preserved for manufacturers to repair and replace complete parts.Generally, we still recommend buying a good Mountaineering stick to avoid the climbing rods during the climbing on the way to the mountain.