Special Mic What are the precautions for the tie of the fish hook?
Fish hooks are commonly used tools for fishing. They are usually tied with fish lines. There are many ways to tie Fish hooks. The following introduces several commonly used fish hook hook methods:
1. Method 1: Wrap the line to the hook handle, and then slowly wrap it around, leave the head head and tighten them hard.
2. Method 2: Wrap the wires into two coils, then turn one of the coils below the hook handle, then put the other section of the coil above the handle, then tighten it, and then wrap the remaining thread around the line.Out of a coil, wear it out of it, and finally tighten it.
3. Method 3: First walk a section of a line onto the handle, pull the head end of the head to the head of the handle, then wrap the other line to the line, then tighten it, and then tie the end of the end.Essence
4. Method 4: First wrap a section of line under the hook handle, then slowly wrap it, put a end line head from the opposite circle, and then tighten the other line head from the circle.It's okay.
5. Method 5: First, the line of the line is wrapped into the head of the hook handle, so that the line forms a semicircle, then pulls a line head, and tighten it out of the circle to tighten it.
6. Method 6: You need to wrap the line to the hook handle, wrap it around at least one or two times, and then tighten it.
7. Method 7: First fix it with a ruler, wrap a section of line from the bottom of the hook, leave the line head to go out from the circle, and wear the other line head from the opposite circle.Remove it, and finally tightly tightly.
8. Method 8: First, slowly wrap a line on the head of the hook handle, and then select a line head to go out from the circle, and finally tighten it.
9. Method 9: Slowly wrap a section of line from the bottom of the hook handle, put one end line out of the circle, and then wear the other end line from the coil in the opposite direction, and finally tighten it.
10. Method 10: Wrap the line from the middle position of the distance to the hook to the hook, and then tighten it after wound, but leave a small coil, put a end line head into the coil, and finally tighten them hard to tighten it.It's right.
11. Method 11: Select a small section line, tie it to the hook handle, and then wrap the remaining lines onto the handle, all the wraps in the hook handle.
12. Method 12: Wrap a section of line onto the handle, then put the line head into the wrapped coil, and then tighten it.
13. Method 13: Select a section of line and start wrapped from the bottom of the hook, leaving a part of the line header tightened.
14. Method 14: First wrap a section of line into the hook handle, leave a part of the coil temporarily, and finally tighten it slowly.
2. What are the precautions for tie Fish hooks
1. When the hook is tied, there should be a certain line length, and each time the fish hook must be tied to a line head with the same length, so that the tie is very neat to ensure that the child line length is the same.
2. When tie the hook, you must gently walk around (five or six laps) when the hook handle is winding.
3. When tightly, slowly pull the head head, which can minimize wear.
4. This one is very important to avoid many broken line phenomena. When tightening the line, the front of the line is bypassed the hook handle, because the hook handle is tilted backwards.Causes the line.
5. When tied the hook, you should also pay attention to making the hook line on the inside of the hook handle. This is important, but it is easy to ignore. The tie line is on the inside of the hook handle to meet the requirements of the force.fish body; if the hook wire is on the outside of the hook handle, it is not only easy to decompose, but also when the hook hook is stressed, the end of the hook handle is also easy to wear the hook wire to cut the fishing line.