What are the precautions for the use of strong light probe lights without light maintenance method?

1. Strong light probe Lights do not light up for maintenance method

Detective Lights are a very easy -to -use Tool when traveling outdoors. It can be manipulated or worn on the head to provide long -range lighting effects. However, sometimes due to the quality of the detection Lights or improper use, the probation Lights fail.In the case, how can I repair the strong light probe?

The structure of the probe lamp is relatively simple, including a switch, the battery placement position and the lamp head of the back of the rear. During maintenance, we can use a small cross screw knife to check the fault one by one and repair:

1. First of all, see if it is a switch or where the contact is poor. If the switch is pressed repeatedly, there is no shiny trace of the lamp beads, which means that it is not a problem of poor contact.

2. Open the battery placement in the back, change the battery, see if it is the problem of the battery or there is no charging.

3. After excluding the above reasons, the rest is the failure caused by the internal line. This needs to be removed and repaired. The specific method is to hold the light head in the right hand, rotate the lamp head in the counterThe connection point of the circuit and the circuit board of the light line and the light head, if it is intact, exclude the possibility of some lines of the lamp head; if there is a problem, connect the line, and the specific method isCome down, expose a long section of metal wire, and wrap the metal wire to the disconnected battery base metal piece, and tighten it.

4. Then put the lamp head back, insert the cross screw knife to the place where the lamp head and the rear part are connected, hold the other end of the screw, rotate the cross screw knife against the right hand, you can twist the screws.Part of the stuck place separate, and then use a screwdriver to remove the two screws of the battery installation position. See if the line between the metal sheet of the battery base and the lamp head is broken. If it is broken, the maintenance method is the same as the step 3.

Tips:When disassembling the battery base, gently separate to prevent too much force from the wire head and the wire between the battery directly. After the line is connected, do not rush to load it back. Try the fault to eliminate it.

2. What are the precautions for the use of the viewing light?

The use of the exploration Lights is limited. In order to facilitate use and avoid failure, we must pay attention to maintaining and maintained strong light probe Lights during use:

1. In the case of long -term use, it must be charged once every three months to keep the internal current Running.

2. Although the probe light has certain protection performance, after all, it is an electronic product. Usually use it away from the water source to prevent short circuit circuit.

3. Do not frequently press the switch when using the probe light to prevent the lamp beads from being broken.

4. Do not wait until the electricity is completed after the electricity is used to avoid loss.