What kind of fishing rod is assembled in the structure of the fishing rod

1. What is the structure composition of the fishing rod

1.

An ordinary fishing rod is composed of a number of hollow matching sections. When not in use, it is embedded and put away.The thinnest section of the matching section of the fishing rod is called section 1; from the inside to the outside, that is, from fine to thick, it is pushed in section 2 and No. 3 ...

2, pole hat

Under the contraction of the fishing rod, accessories are used to block, fix or protect the eyes.Big rods and sea rods generally include hats: direct protection caps, triangular hats, and quilted Fishing rods, etc. The colors are transparent, translucent, black and gun smoke color.

3. Direction eye

The guidance eye is also called the wire ring and the conductor. It is an accessory specially used to take the fish wire. It is an essential accessory for Bijia fishing, sea fishing, and boat rods.The guide ring requires high strength, small friction resistance, good thermal conductivity, and consistent with the fishing of the fishing rod.The general guide ring consists of a bracket and a wire ring. The bracket material is stainless steel, which requires not rust and cannot be too soft. The wire ring material is mostly ceramic ring and silicon carbide.

4, wheel seat

Also called the card seat, it is a special accessory for fixing the Fish wire wheel on the fishing rod.There are two main types, one is a Tube wheel seat, the other is a plate -shaped wheel seat, the former is used for ordinary sea Fishing rods, and the latter is mainly used for the rock Fishing rods.

5. Holder

Also calling the handle or the handle, it is the accessories that have been grasped in the hand during the fishing process.The hand pole is generally a cotton line, nylon thread, or glue handle. Generally, it is preferred to prevent pollution and anti -slip.

How to assemble the fishing rod

First, before assembling the fishing rod, we need to prepare the required materials and tools.Generally speaking, the assembly of the fishing rod requires the use of fish rods, fish lines, Fish hooks, floats, lead and other accessories.In addition, a fish wire scissors, a fine screwdriver and some small screws need to be prepared.

In the first step, we need to pass the fish wire through the rack ring of the fishing rod.The wire ring is divided into different sizes. We need to choose the appropriate wire ring based on the type of fishing rod and the types of fishing.Start through the wire rings at the bottom of the fishing rod, and gradually pass through every wire ring until the top.Note that when passing through the wire ring, keep the fish wire Smooth and avoid crossing or tangling.

The second step is to fix the end of the fish wire on the roll wheel at the top of the fishing rod.The rolling wheel is a device at the top of the fishing rod, which is used to collect the fish wire.We need to fix the fish wire in the fixed holes on the roll wheel and tighten it gently with a screwdriver.After fixing the fish line, you can gently pull the fish line to check whether it is fixed.

The third step is to assemble the other accessories of the fishing rod.As needed, you can add floats, lead or other decorations to the fish line.The float is used to control the floating of the fish wire, and the lead pendant is used to increase the weight of the fish hook and help the fish hook sink to the appropriate position.When assembling these accessories on the fishing rod, you need to pay attention to the fixing method of each accessory to ensure that it is firm and reliable.

Finally, we need to check the assembly effect of the entire fishing rod.You can shake the fishing rod gently and check if there is a loose or unstable place.If so, you can use a fine screwdriver to fix it.At the same time, you can also pull the fish line to check whether it is Smooth and unobstructed.If you find a tangled or stuck, you can use the fish wire scissors to trim the excess fish line to ensure the Smooth fish line.