What is the fishing snowmanship

Snowflake, it is a white sheet made from dehydration, dryness, and expansion.Its texture is lighter, and the proportion of water before absorbing is only about 2/3 of the water.After water absorption, it can appear suspended in the water.

We use cooler powder when we usually make bait when fishing, mainly because of two aspects: one is that it can effectively produce atomization; two is to change the proportion of the bait itself.

When adding cedar powder, you must control its amount. If too much, the bait will become too loose, the atomization is too fast, and the remaining hook is not enough.If excessive atomization, it will attract small miscellaneous fish to affect normal fishing.The appropriate addition of snow pollen can make the bait scatter in the fishing layer we booked, and achieve a good fish -liquidation effect. For example, mixing the snowflore and the large granular granules during the bottom fishing.In the bait, the bait is scattered at the bottom very well, which can effectively lure fish and leave fish.

When floating fishing, we need to increase the ratio of cedar powder in an appropriate amount, which can not only make the bait lighter, but also conducive to fishing, but also make the bait at the middle and upper layer.The ground attracts the nest.

The role of snowflake powder

When we are fishing, whether it is rubbing the bait and fishing bottom, or pulling the bait to fishing the bottom, especially when we pull bait fishing, we can't do without snow pollen.Everyone knows that the snowflore powder is strong. When mixing bait, it plays a sticky effect. When the pole is thrown, the bait does not disperse. After entering the water, the bait begins to be atomized and scattered. A little bait can be left on the fishing hook., And it is convenient for fish to eat.

Snowflames use tips

The amount of snowflake should be dependent on the fishing situation at that time.The depth of water, the height of the water temperature, the size of the fish, the fast and slow hook, the bait, the bait or the rubbing or the rubbing, the bottom fishing or floating fishing, etc. to comprehensively determine it.Generally, it is: deep water, large fish, low water temperature, and slow food hooks. When fishing for the bottom, it should be added appropriately, and the contrary will be less.The specific amount of additional amount is also asked to ponder and summarize more in practice.

Is it useful?

The waist is also called a Belt and a Belt.In sports, the waist is used to protect the waist from harm, insulation, or certain special functions.In sports, the waist is often nervous due to excessive resistance to exercise, high strength load, and soreness.Wearing the appropriate material and specifications can effectively protect the waist tissue and prevent exercise damage.

Good waist guards can not only fix the waist, keep warm, but also release far -infrared and negative ions.And bring a micro -current thermoelectric stimulation effect to the human body.It can effectively improve blood circulation, alleviate muscle fatigue, activate cells to promote metabolism, dredge meridians, eliminate wind and dehumidification, analgesic and cold, and enhance the body's disease resistance.

The role and efficacy of the Belt

1. The waistband has a pressure effect.Apply a certain pressure on the muscles to regulate the balance of exercise.To a certain extent, strengthen muscle strength and reduce swelling.The muscles are stimulated during exercise, and proper pressure to exert pressure can help exercise easier and powerful.

2. The waistband has a supporting effect.The harder waist custard can provide a certain support during the movement, hold on the waist that is too large, reduce the muscles, and protect the waist and not sprain or sore.Some functional waist guards are attached to the back of the back of the waist, which can effectively provide greater support to avoid accidental damage. The rear of this waistband is generally higher.

3. The waistband band has the effect of insulation.The softer and comfortable waist of the double or multi -layer material has a strong insulation function.Athletes often wear less in sports, while waist heat dissipation, easy to get cold, causing people to be sour, spasm or causing discomfort in the stomach.The waist protection of the insulation performance can effectively maintain the waist temperature, accelerate blood circulation, and prevent some discomfort in the cold and stomach.

4. The waistband band has the effect of shaping.In the movement related to the waist, pressurizing the waist -absorbing waist -absorbing waist can speed up the decomposition of fat, which is a must -have protective gear for waist fitness.Strengthen cell metabolism, burn fat, regulate looseness, and apply appropriate pressure to help lose weight.In the movement related to the waist, pressurizing the waist -absorbing waist -absorbing waist can speed up the decomposition of fat, which is a must -have protective gear for waist fitness.

How to buy the right Belt

1. Choose according to the purpose.One is to provide protective health care belts for lumbar discomfort or lumbar spine diseases.Another is the Belt that specializes in providing Bone protection for postpartum women, also known as beam Belt.The shape of the two types of belts is very similar, but the effect is very different.Therefore, when buying, you must buy according to your actual situation.

2. Select according to thermal performance.The main role of the Belt is to protect the waist and relieve pain.If you think of a certain treatment and health care, it is best to buy a Belt with spontaneous thermal function.

3. Choose according to the fabric.The key to the selection of waistband materials is to see if the material is thin and breathable.Whether it is winter or summer, if the waist guards cannot be sweaty, then wearing it will become a kind of suffering.

Applicable symptoms of Belt belt

1. Rehabilitation and treatment of Bone spurs, low back pain, sciatica and other diseases.

2. Prevention and auxiliary treatment of lumbar spondylosis such as lumbar spondylosis, lumbar muscle strain;

3. After lumbar spine surgery or the stability of the rehabilitation period of lumbar disc herniation;

4. The protection and support of the waist of the waist of physical labor and the old body of the old body;

5. Eliminate or relieve the discomfort of the waist, abdomen, and back caused by excessive work or fatigue.

6. It can be used in the winter waist guards and women's postpartum abdomen and abdomen.

How to use the Belt

1. When lying flat, put the waistband behind the waist, buckle in front of the abdomen, and adjust the elastic band on both sides to the comfortable position.

2. When standing, try to straighten your waist as much as possible, put the Belt behind the waist, buckle in front of the abdomen, and adjust the elastic band on both sides to a comfortable position.

Belt use crowd

1. Lumbar disc protruding, lumbar spine hyperplasia, dislocation, lumbar muscle strain, sciatic nerve and other people with various lumbar spondylosis and rehabilitation treatment after surgery;

2. Long -term engaging in class, driving, and old lumbar vertebrae degenerate diseased people with pain and sour derivatives;

3. Lumbar and abdomen hypertrophy pain, postpartum lumbar spine deformation women, lumbar spine pain groups;

4, after 35 years of age, to avoid the deformation and dislocation of the lumbar spine, share the pressure of the lumbar spine;

5, wind, cold and dampness, backache pain, sour fatigue, lumbar muscle strain, soft tissue injury, Bone hyperplasia, external injury pain and other people;

6. Suitable for long -distance drivers to maintain the same posture for a long time.

Common fault inspections and maintenance of bicycle code tables

1. Check whether the distance between the magnet and the induction switch meets the requirements. If the distance is too far away, it will affect the accuracy of the speed.

maintenance method: adjust the distance between the magnet and the induction switch to the right distance.

2. The contact point of the code watch and the circuit on the seat is dirty, causing poor contact.

maintenance method: Use fine sandpaper to polish.

3. Check whether the connection line of the induction switch to the code table has internal disconnection, resulting in intermittent interruption.Checking method: Dial the multimeter to the "RX1" file, and the red and black surface needles are connected to the two electrodes on the codes. At this time, the front wheels should be turned, and the pointer of the multimeter should be swinged left and right.

maintenance method: The induction switch is normal and the connection is normal; if you do not swing or dial the line gently, the intermittent time is open, there is a breakpoint of the connection, and the connection line needs to be replaced.

4. The above are normal. Please check whether the battery of the code watch should be updated?Using the universal DC voltage V10, the battery voltage for various tables may be different.

maintenance method: As long as the measured voltage is below 60%of the original battery voltage, the battery needs to be replaced.For example, the LR44 twist battery should be 1.5V. If the measured is & lt; 1.0V, the same type of battery needs to be reduced.

5. The code watch may enter the water, causing internal line failure.

maintenance method: Open the rear cover and put the code watch for about 30 minutes at 10-20 cm from the incandescent lamp, but pay attention not to be too close, due to the high temperature damage circuit.

6. If the LCD screen of the code watch is black.

maintenance method: It means that the code watch is damaged, then you need to change the new watch.

7. Because the magnetic body of the bicycle watch is installed on the barrier, it is often in a fast rotation state, and it is often easy to change or even fall off due to touch, collision, and rubbing.

maintenance method: If it is lost, it can be self -made.The method of repairing the bicycle code is as follows: Find a small magnet (such as a magnetic door touch and a small magnet in the Headset, with small size, strong magnetic force, light weight light), a small aluminum Skin, a bottle 502 502Powerful glue. First cut the small aluminum Skin with scissors to 15X20mm; Then fold it on the position of the bar that needs to be installed (form a U -shaped); Inject an appropriate amount of "502" glue in the middle of aluminum Skin and magnets, so that the magnets and aluminum Skin are firmly stuck (about a few minutes); Adjust this magnet up and down to the right position, and inject "502 ".After drying, adjust the position and position of the induction switch, that is, the sue is successful.

How to wash down the down sleeping bag

Because the fillers in the down sleeping bag are down materials such as duck and goose feather, duck and goose down, they must pay special attention to the cleaning method when cleaning. For the uncommon fabrics such as down Sleeping bags, many dry cleaning shops cannot master its correct washing methods.Generally speaking, the down sleeping bag is cleaned once every 4-5 years. This interval can not only properly extend its service life, but also avoid the trouble of cleaning caused by too much cleaning.

During cleaning, it is divided into two types: hand washing and machine washing. When hand washing, you should choose a dedicated down detergent. After soaking in the instructions, wash it after soaking it. Do not rub it hard to avoid damage to the filling in the sleeping bag.If you choose machine washing, you must choose a dry cleaning company for a specialty washing bag. After getting the clean sleeping bag, you must lightly pat it to confirm the drying.The same method can also be used in hand washing. After washing, make sure the down sleeping bag is dry, and then gently pat it to let it show a natural fluffy state before it can be put into the storage bag.

precautions for Plel Sleeping bags cleaning

1. Please use a neutral detergent or special sleeping bag cleaning agent to clean your sleeping bag. Do not use strong cleaning agents, bleach and clothing.

2. Soak the sleeping bag before cleaning, and use a soft brush to gently brush the head, neckline, feet and other vulnerable parts to reduce cleaning work.

3. Sleeping bags can be washed with front roller washing machines, but the upper -style turbine washing machine cannot be used.Before the machine was washed, the sleeping bag was turned off, pulled all the zippers and buckled it.Select warm water and mild mode for washing machines. Do not use drying function. Strong centrifugal force will damage the fabric and lining of Sleeping bags.

4. Rinse the detergent and soap foam thoroughly.

5. After cleaning, do not pick up the down sleeping bag from one side, but pick up the sleeping bag from the bottom, otherwise it will damage the fabric and lining of the sleeping bag.

6. Frequent transitional washing will damage the warm -fitting medium of down to Sleeping bags. Therefore, please minimize the number of washing times while keeping cleaning.

7. Sleeping bags are suitable for drying and drying in a ventilated and dry environment to avoid strong sunlight. UV rays will damage the surface of the nylon.

8. You can use a large commercial dryer with a large capacity. You must keep low temperature drying and have enough room for Sleeping bags.

9. After drying, please continue to shake the sleeping bag and gently pat the duvet tangles to make the down completely stretch. After the sleeping bag is restored, put it in the storage bag.

Disclaimer: The above method stems from the index of the program system or the sharing of netizens. It is for your reference only and does not represent the research perspective of this website. It proves that it is valid. Please pay attention to the authenticity and authority of the source of the content of the content.Apply to delete & gt; & gt; error correction & gt; & gt;

1. What is the lease price of the Tianmu Tent

For novice Camping, the scenic spots that can be Tent and Picnic are very friendly.

Once the gameplay is more abundant, appreciate beauty, play entertainment projects, and double happiness; more importantly, you can use supporting facilities in the scenic area (such as water purification, toilet, self -service vending machine, etc.).So what is the lease price of the Tianmu Tent?

Generally speaking, 4-6 people are 150 yuan/piece (including a sky curtain, lighting, supporting tables and chairs).There is also a more cost -effective package:

1. About 10 people Classic package: Skymen folding tables and chair barbecue rack Picnic cushions 288 yuan/set/time.

2. About 10 people Hi -leather package: Skymen folding tables and chair barbecue rack Picnic padding sound 338 yuan/set/time.

(The price comes from the Internet, for reference only)

2. What are the precautions for leasing of the sky curtain Tent?

1. First of all, we should ask for the cleaning process of Outdoor equipment service providers. Whether there are disinfection, cleaning, and drying these two professional Links.Try to ask photos as much as possible.

2. Secondly, pay attention to check whether it is clean, and pay attention to whether it is damaged.

3. When using, pay attention to personal safety, avoid traveling alone, and try to avoid barren mountains and river channels.There must be professionals accompanied by professionals.Entering winter, on the one hand, fire prevention awareness must be enhanced. If you want to use fire, you can put some fire blankets on the ground. The fire extinguisher is also necessary.In addition, pay attention to avoiding cold. Generally, it is not overnight. Even if you spend the night, you must prepare enough warm Sleeping bags and sleeping mats.