1. How to make creativity link

1. Link the bottle cap

Use the two vertical lines on the two sides of the bottle cap as the two sides, and keep the two vertical lines at about 1cm as much as possible. Then, use a knife to cut the bottle cap along the vertical line to remove the two pieces.After this step is done, two grooves will be formed on the bottle cap, and it is precisely these two grooves that can be used for Hanging things.Finally, the bottle cap is pasted and fixed on the wall. At this point, a simple hook is done.

Or I think it is only monotonous with a bottle cap, which is too simple, and you can also choose to add a few back -shaped needles.In this way, you do nt need to cut two pieces on the bottle cap to form two pieces to form things Hanging. Instead, the back -shaped needle is poured into a wire, and the tail is bent into a small hook.Put the back -shaped needle in, and then fix the bottle cap to the wall, and the hook is completed!

Although this hook is easy to do and the cost is very low, there is also a small defect, that is, it is only suitable for putting some small things, or some light debris, otherwise it will be easy.

2. hook branches

When you go to the Park to take a walk, you can pick up some small branches with a lot of branches, and then trim them into similar sizes, and then brush it on your favorite color.The screws nail them in a row.

It is firm and very high -level. No matter where you hang it, there is a natural charm, which immediately enhances the style of the home.And the hooks made of this are relatively strong, it will not fall easily, and there are more things that can be hung.

two,Wall linked DIY handmade tutorial

tools/raw materials:Small brush, a cup of water, paper towels, palette, tape, nails, hammer or screwdriver,Three colors of pigments, wooden knobs, and threading.

Method/Step:

1,Open the pigment box, freely match different colors, mix or alternately use.At the beginning, it is recommended that you start with a simple color.

2. Use a pencil to mark the part that is about to colored, and the tape sharing area.

3. Dig a little pigment with a small brush at the end of the brush and put it in the palette, and change the color by mixing with water or mixing with other colors.After digging out a piece of paint, clean the small brush, continue to dig the second color, and mix them.

4. When you make up your satisfactory color, you can start coloring. Mix the paint with a brush head with a pen and dip it out.

5. color according to the area marked.

6. Put the colorful knob on one side and clean the pen in the water.

7. After the pigment is dry, remove the tape.

8. Tort the threaded screw (actually matched with the knob) to the behind the knob until it is completely fixed.

9. Use a hammer and moderate nails on the wall to cut a small hole, or directly use an electric screw knife to hit a hole.

10. Fix the hooks that are done on the wall, and you can hang your favorite jewelry or clothing.

11. After the operation is skilled, you can make various colors and styles of wall linked, gradient, Pop, stripes, geometric patterns to choose from.

1. The difference between linked curtains and punching

1. Applicable place

Pole curtains are generally suitable for large -area windows, such as to separate the living room from the balcony.If it is a floor -to -ceiling window, it is also very suitable for using punching curtains.The linked curtains are generally used for four -claw hook and S hook. If this curtain is suitable, all occasions are suitable, but many people still use it in the bedroom.

2. Disassemble

The curtains also need to be disassembled regularly, because long -term suspension, a lot of dust will fall on it.In terms of disassembling and washing, punching curtains are easier to disassemble. Take the curtains and Hanging rods together, and then take the curtains from the pole.The linked curtains will be more troublesome if it is removed, because it is necessary to remove all the hooks before being washed.After cleaning, when Hanging, it is also very time -consuming to install these hooks and reinstall it.Relatively speaking, the hook cleaning and installation are more troublesome, and the punching curtains should be much easier.However, when cleaning, the thickness of the hole curtains is thicker, and the difficulty of cleaning has increased a lot.The hook curtains should be thinner, not so difficult to clean.

3. Beautiful

Generally speaking, the prices of punching curtains are more expensive.The overall feeling of the punching curtains is very good, and it looks very atmospheric.Overall, punching curtains should be more beautiful and stronger, and can enhance the sense of grade of space.The overall sense of the linked curtain is not so good, and the price is relatively cheaper.Although the hook can determine the amplitude of the curtain folds, it is still a bit inferior.

4. installation method

There are still obvious gaps in the installation method of linked and punching curtains. The hook requires you to calculate the distance measurement in advance.Then you need to adjust the number of inserted pins into the slot. Generally, there are 3-4.After that, you need to consider the number of caves in the middle, which is more troublesome.The installation method is very simple in installation. You only need to put on the hole of the curtain into the pole at one time.

Pole -and -hook curtains have their own benefits. Good or bad depends on personal preferences.They have their own advantages and disadvantages. When choosing, they can choose according to the place to be installed and the decoration style they designed.

2. How to install the hook curtains

1. installation of the top seat

After the location of the curtain linked is determined, take the drill drilling hole. After the drill is drilled, the expansion screws are fixed to the four top seats (if the pole grows greater than the conventional size, this length is adjusted accordingly).

2. Install the curtain ring corner

The curtain linked angle can be installed on the top of the balcony or the top of the wall, and the corner is 50--70cm from the top seat of the activity. It is necessary to form a triangle (45 degree angle) and the position of the shaking hands in the middle of the top seat to maintain the same vertical line.

3. Steel wire connection

A set of curtains contains two steel wires. Take out one first. First, the end of the steel wire through the corner bearing wire groove, and then pass through the active wheel bearing wire slot on the top seat, and then pass through the fixed top top seat.The bearing wire groove makes the wire vertically on the ground, and then puts the top cover from the wire to the top cover.The other end of the steel wire is the same.Another steel wire installation method is the same as root.

4. Curtain rod connection

At the end of each steel wire, wear a Hanging ball and knots in the Hanging ball; then pull the Hanging ball until the top seat is held.On the side of the shake; relax the steel wire in the hand shake, the Hanging ball drops, pass the curtain rod through the Hanging ball, and then tighten and fix it at the position of the Hanging of the Hanging ball, nail the screw;Cover.In this way, the installation of the curtains is successful.

3. precautions for the installation of curtains

1. When installing the curtain hook, the distance between the hooks should be as uniform as possible, and the calculation is calculated first.

2. Pay attention to the rusty hook, you should change it immediately to avoid polluting the curtain cloth.

3. In actual use, you can adjust the number of inserted pounds, 3, or 4; you can adjust the number of Hanging grooves between the interval between each two hooks, so that the effective width of the curtain can be adjusted.