How to make a creative hook wall hook DIY handmade tutorial
1. How to make creativity link
1. Link the bottle cap
Use the two vertical lines on the two sides of the bottle cap as the two sides, and keep the two vertical lines at about 1cm as much as possible. Then, use a knife to cut the bottle cap along the vertical line to remove the two pieces.After this step is done, two grooves will be formed on the bottle cap, and it is precisely these two grooves that can be used for Hanging things.Finally, the bottle cap is pasted and fixed on the wall. At this point, a simple hook is done.
Or I think it is only monotonous with a bottle cap, which is too simple, and you can also choose to add a few back -shaped needles.In this way, you do nt need to cut two pieces on the bottle cap to form two pieces to form things Hanging. Instead, the back -shaped needle is poured into a wire, and the tail is bent into a small hook.Put the back -shaped needle in, and then fix the bottle cap to the wall, and the hook is completed!
Although this hook is easy to do and the cost is very low, there is also a small defect, that is, it is only suitable for putting some small things, or some light debris, otherwise it will be easy.
2. hook branches
When you go to the Park to take a walk, you can pick up some small branches with a lot of branches, and then trim them into similar sizes, and then brush it on your favorite color.The screws nail them in a row.
It is firm and very high -level. No matter where you hang it, there is a natural charm, which immediately enhances the style of the home.And the hooks made of this are relatively strong, it will not fall easily, and there are more things that can be hung.
two,Wall linked DIY handmade tutorial
tools/raw materials:Small brush, a cup of water, paper towels, palette, tape, nails, hammer or screwdriver,Three colors of pigments, wooden knobs, and threading.
Method/Step:
1,Open the pigment box, freely match different colors, mix or alternately use.At the beginning, it is recommended that you start with a simple color.
2. Use a pencil to mark the part that is about to colored, and the tape sharing area.
3. Dig a little pigment with a small brush at the end of the brush and put it in the palette, and change the color by mixing with water or mixing with other colors.After digging out a piece of paint, clean the small brush, continue to dig the second color, and mix them.
4. When you make up your satisfactory color, you can start coloring. Mix the paint with a brush head with a pen and dip it out.
5. color according to the area marked.
6. Put the colorful knob on one side and clean the pen in the water.
7. After the pigment is dry, remove the tape.
8. Tort the threaded screw (actually matched with the knob) to the behind the knob until it is completely fixed.
9. Use a hammer and moderate nails on the wall to cut a small hole, or directly use an electric screw knife to hit a hole.
10. Fix the hooks that are done on the wall, and you can hang your favorite jewelry or clothing.
11. After the operation is skilled, you can make various colors and styles of wall linked, gradient, Pop, stripes, geometric patterns to choose from.