Can the wild camping lights be changed to the bulb?

1. Can the wild Camping lights be replaced with a Light bulb?

Camping lights play an important role when Camping in the wild. Many of the Camping lights now are LED electric Lights and use LED bulbs. If the light bulbs are not bright enough or bad, you need to replace the bulbs. Can the wild Camping light be replaced?

Generally speaking, the bulb of the Camping light can be replaced. If the bulb is not on, or it suddenly burns, you can remove the wild Camping light, remove the bad light bubble inside, and re -change the new one.However, when you go to Camping, you will not bring an additional Light bulb, so you usually replace it after returning home.

2. How to change the Light bulb in Camping lights

The Camping lights are generally LED bulbs. The replacement method is similar to the ordinary LED bulb replacement method. The specific method steps are as follows:

1. Before changing the bulb, we must first disconnect the switch of the wild Camping lamp to avoid the risk of electric shock. Then safely remove the Camping light, wipe the dust of the dew luminous light with a clean dried Pozi, and then put the lampshade on the outside.Take it down.

2. After taking off the lampshade, if you find that the bulb has been black, it means that the bulb has been broken. It is likely that the filament is burned. You need to buy a installation again and select the LED bulb with the same specifications.

3. Next, remove the original Light bulb. Generally, according to the structure inside, the deck of the fixed LED Light bulb is opened, and then the bulb is taken out. In fact, the installation of the Light bulb is generally equivalent to inlaid in it.As long as you find the source of the bubbles inlaid and pull it off, it is not difficult to operate.

4. Press the new Light bulb and pour it back to install again.That is, the newly bought Light bulb is fixed with a scavenger, and the other end is connected to the power supply. After installation, see where it is not installed, especially the side of the power supply.

5. After the installation is completed, install the lampshade, turn on the switch to try, and just light up.