Leaf wood breeding methods and precautions become leaf wood maintenance knowledge

1. Method of breeding of leaf wood

1. Soil: The soil is fertile, humid, and well -drained soil.Potted plants can be mixed with 3 parts of garden soil, 1 part of the pile, 1 part of river sand, or 3 parts of rough peat, 3 parts of corrupt leaf soil, and 2 parts of sand as a matrix.

2. Sunshine: The range of leaf wood is wide to the light, but the sufficient sunlight is conducive to promoting its good growth and obtaining higher ornamental value.Therefore, in addition to proper shade in the summer strong light, the color of the blades in spring, autumn, and winter becomes more beautiful under the condition of open -air light.The leaf wood is not too shade. It is generally suitable for the strong astigmatism in the room, and the time should not exceed 2 to 3 weeks.If long -term lack of light or insufficient light, the leaf color will lack luster, and it is easy to fall into leaves.

3. Watering: The growth period of the leaf wood from May to October should be given enough water to spray water on the leaves and ground every day to maintain high air humidity and Smooth leaves.The amount of watering gradually reduces the amount of watering in the end of autumn and winter, but pay attention to spraying water on the leaves to keep the indoor air humid and proper ventilation.

4. Temperature: The leaf wood is hot and chills. In winter, the indoor safety and wintering temperature are 10-15 C. It is prone to dehydration when it is lower than 10 C, and water stains or discoloration will also appear on the branches.summer can adapt to high temperature above 30 C.

5. Fertilizer: Generally, leaf wood is generally applied to rotten liquid Fertilizer every 2 weeks.Do not have too much nitrogen fertilizer, otherwise the leaves will become green, dim, and not gorgeous.From late autumn to winter, less fertilization or not fertilizing, so as not to draw new shoots.

6. Prevention and treatment of diseases and insects: If the cultivation environment is high temperature and dry, leafwood is prone to harm of script insects, red spiders, aphids, red spiders and aphids can be sprayed with 1,000 times to prevent and control.If you have a smoke disease, scrub with water or spray a multi-bacterial spirit 500-1000 times liquid.

2. precautions for breeding and turning the leaves

1. Properly trim the growth rate of the leaf wood is relatively fast. Usually you need to prunites the leaf wood in time, otherwise it will affect the growth of the plant. Whenever the leaf wood grows strong, the long side branches will be properly trimmed and the yellowing will be yellowed.The cutting of the branches and leaves can reduce the consumption of soil nutrients and promote the growth of leaves.

2. Although the requirements of leafwood in winter are not high, the leaf wood is not cold -resistant, and it cannot grow at a temperature below 5 C.Temperature control is above 5 C, prompting leafwood to thrive.

Third, the method of breeding of leaf wood

Multi -cutting method of breeding and turning the leaf wood.

1. From April to May, the top -growing top -growing tender branches are selected as cuttings, and semi -wood branches with 2 to 3 knots are cut to retain a few leaves on the top.

2. Wash the incision, apply it with plant ash, and dry it with a slightly dry sand and the mixing of the plants and gray.

3. After insertion, use plastic film to keep it moist, put it in a cool place, and control the temperature between 24 C and 30 C. After about 3 weeks, you can take root.

4. After a month, you can move the seedlings. The cuttings of the old branches are not easy to take root.The cultivation management of leaf wood is simple. Except for one trimming and plastic surgery every spring, no other special management is required.The northern pot is out of the room in early May.