How to install the home solar lamp?

1. home Solar lamps, okay?

Solar Lamp is a new type of environmental lighting lamps. It uses solar energy as its main energy. As people's environmental awareness is strengthened, Solar lamps are used in major fields. Common Solar street lights and Solar courtyard Lights.How about the lamp?

Generally speaking, Solar lighting lamps are also better. On the one hand, its power consumption is relatively low, because it can collect solar energy. If it is rainy weather, it can also be used by the solar energy stored before, or the municipal power function; on the other hand, on the other hand, it can be used;The home Solar Lamp is also relatively safe. Usually, 9V voltage is used to power, and there will be no errors to touch the lamp head and electric shock.

Solar lamps have two types: split type and integrated. Generally, families are more suitable for using integrated Solar lamps. Although the efficiency of solar energy may be less efficient, it is more convenient.

2. How to install Solar lantern hives

The family uses Solar lamps must be installed first. The installation of home Solar lamps is divided into four parts: battery board, battery, controller, and wire. The specific installation method is as follows:

1. Install the panel

Determine the tilt angle of the battery board according to the local latitude and other to ensure that the battery board has sufficient Solar irradiation.After determining the angle, fix the bracket at the position of the Solar light, and fix the battery plate on the bracket.

2. Install the battery

According to the design requirements, dig the box pond well, and put the buried box with the battery into the pool, lead to a wire Tube, and cover the cement board.Before putting the battery in the ground box, you need to determine whether the battery is intact. It is usually recommended to put in the same model and the same specifications and connect the battery in series.The burying boxes need to be used for glue, and the protective Tube is tightly fixed.

3. Install the controller

The controller generally uses a special controller of Solar power supply. When the connection is connected, connect the wiring terminal of the battery on the controller, and then connect the photovoltaic panel wire wire, and finally connect the load terminal.Be sure to pay attention to the battery, photovoltaic battery panel, load,-extremely cannot be connected, otherwise it may cause short circuit.After connecting the line, place the controller in the lamp column and fix it with bolts.

4. Pay the wires

Put the lamp head on the lamp arm, adjust the irradiation angle, and tighten it with the screw.Connect the lamp head line with the Solar panel and tighten the waterproof joint.After receiving it, test whether the Solar Lamp can be used normally, and it can be put into use normally.