planting method of Artificial lawn
one,Sowing method
Most lawn can be sowed or sowed in spring or sowing seedlings in late autumn.When a lawn is established in large areas, sowing machines can be sowed, and small area sowing is used in small areas.After sowing, use a rake to rake each other, and then suppress it with a wooden cricket.After the granular seeds are planted, the straw should be covered.The sowing method requires skilled sowing technology to ensure uniform planting.In addition, management is more expensive.
Second, paving method
Although this method can quickly build a lawn, the process is too complex and the investment is large.
three,Stem
Forcetic straw species, such as Dogs, Carpet grass, fine leaves, creek cuts, bull grass, etc., can be reproduced with stems.It is best to do it when the grass Skin is germinated in early spring, or it can be carried out in the rainy season.First cut the stubs from the lawn floor and cut it on the shade of the shade5--8In a small section of centimeters, there must be a section on each paragraph, otherwise the new root cannot be germinated.Then broadcast or sprinkle.
Broadcasting: In a flat location, open shallow grooves with a small pick, pour foot water, and use the water to seep2-- 3The strip is a bouquet of the ditch, and the soil is covered on it1Centimeter, line spacing20Cm, spray water every day in the future1Second, after the new bud is unearthed, spray water.
Sprinkle: first pour the ground through the water through the water, seep the water, and then sprinkle the cut stems on the soil surface and cover it up.1Cm thick thin soil.
Four,Roots
This method is suitable for plants without stems and most of the grass species, such as sheep -bearded grass, velvet, etc.Time is best in early spring or rainy season.Shake off the soil after placing the root of the densely dense place, remove the weeds, cut off part of the whisker, so as to2-- 3The seedlings are a pinch, tear it open, and then planted or planted according to a certain plant distance.Follow the soil, cover the thickness of the soil2It is advisable to be about centimeters.Gently compacted after covering the soil, and fully irrigated.Before the new leaf germination, spray water every day1-- 2Second, to prevent the soil plate and crack.
Under normal circumstances, the method of planting turf is simple and easy to save funds.
What is the planting step of Artificial lawn
Step 1: finely neatly
The lawn has high requirements for soil conditions, and the land is required to be very flat before laying.
1Filling back to the soil is full and slightly higher than the design elevation. Generally, the height difference is3~5Within centimeters.
2, clean up the venue30cmAll small stones and other objects within the depth.
3If the grass design with terrain, be sure to ensure Smooth and full terrain.
Step 2: Soil improvement (sand spreads)
1, Sprinkle suction and humus soil, river sand, etc. to improve the soil
2, Roll the soil behind the river and sand with the wooden strips
In order to ensure the follow -up growth of the lawn, you can also sprinkle some compound Fertilizers appropriately. At the same time, the bottom Fertilizer should be applied to the entire land. Conditional regions can be applied to rotten Organic fertilizer, and chemical Fertilizers can be used.5Grace, potassium chlorine5gram
Step 3: Lawstins
1Before planting, the soil layer will be flattened
2When planting, it should be used to keep the lines, keep the lawn's flat, tidy, and uniform
Note that there are no gaps in the garbri babes. Generally, the specifications that are best selected are300*300mm
Step 4: crushing
1Generally, three crushing is required to ensure that the sand soil layer is fully contact with the turf
2There are many ways to crush: If the area of the turf is large, the drum can be used. If the area is average, it can make a roller, and the manpower can be pulled.If it is sporadic grassland, you can make the workers try hard with iron.
Step 5: Watering
1If there are large grasslands such as parks and golf grasslands, the automatic spray irrigation system is generally installed. Just open it immediately after the grass laid laid laid.
2If artificially irrigation, be sure to pay attention to the first watering, and consider the settlement of the soil, sand, and turf with sand.
Step 6: Daily Pruning
Generally, the grasslands just paved do not need to be grass, because after crushing and watering, the grass is tight.Need to pass10Began to get grass around the sky.If you encounter sporadic weeds, you need to clean up in time.
Step 7: Makes insulation measures
In winter to promote the germination of the lawn, the lawn can be used to keep the lawn with non -woven fabric (breathable insulation).The film is used to keep the insulation without good breathability, and it should be removed regularly.
How to plant a beautiful lawn for lawn seeds
First, clean up all weeds in the planting area, previous grass, and other debris.
The chemical treatment method is: spray glyphosate to kill all plants in the area (if necessary).These toxins (glyphosate) may have a long -lasting effect on the soil.Properly flip the soil, so that the soil and weeds can be loose, which is conducive to collecting these weeds.If you have time, you can let the land idle for a week and water the land appropriately.This is a good way, because after this time, the weeds under the ground unearthed, so that you can remove them before planting the lawn.
Second, let the soil fully contact the air and soften it.
You can use hoe, plow or shovel to turn the soil. What tools are used depending on the size of the land.Before planting the lawn, you can pile up the soil (so that the soil can be improved).
three,Since the weeds on this land have been cleared and the soil has been turned over, the next thing to do is to make appropriate grades.
This can ensure that there is a certain small slope between the lawn and the infrastructure of the house, at least every10foot(3Mi) Reserve1inch(2.5The height of cm).
Fourth, when turning the soil, a large amount of weed seeds will be turned to the surface of the soil, and these seeds will germinate and compete with the newly planted grass.
Watering the soil before sowing (weekly1-2Times), and then spray the pesticide again, remove all weeds, so that no other plants will compete with new grass.
Fifth, apply small seedlings and sprinkle lime.
Fertilize the grass according to the guidance (control ratio) on the Fertilizer packaging.It may be a good way to use the Fertilizer, because it can ensure the accuracy of fertilization.Lime is prepared for acidic soil (acidic soil is widely distributed in the northeast region).Especially when there is an evergreen tree or shrub in the planting area, you can conclude that these soils are acidic soil.If you really want to determine the nature of the soil, you can get the soil sample to the local cooperative office to test it.If you have improved the soil and the soil is good, then you don't need to sprinkle import Fertilizer.
6. Type the soil as much as possible.
planting lawns on soft soil is not a good idea.You can use hand ramming or other things to rectify the soil. What tools are used depends on the size of the land area.If you fall down a lot of soil, then you are better to layered them and fight them.actually,13-15The soil with deep centimeters is not thick.If you want your lawn to grow all year round, then you must pay attention to these things.When rammed soil, using water rollers is not a good way. If necessary, it is best to use the rammer.
Seven, the surface of the land needs to be rough.
Use the dumplings to make the soil surface slightly rough.You need to leave some gaps to take root.
Eight, sowing.
Use an appropriate seeding machine and sow according to the proposed proportion prompting on the seed packaging bag.It's not good to sow too many seedsThe this will not make the lawn grow faster. On the contrary, this will cause the lawn to be crowded, which will cause the grass to suffocate and die.
Nine, make sure the seeds and soil are fully contact.
At this time, you can use water rollers to stuff the seeds into the hole (loose place) of the soil surface.Or, you can also use garden .Don't worry that most seeds will be exposed to the air because it is a good thing.
Ten, sprinkle peat soil or Fertilizer.
The peat soil or Fertilizer can be used as the protective layer of the seeds, and the other is to be used as a cover.If you want to spread a thin layer of coverage for the seeds, then use some container to make these things.You only need to bury the seeds into the soil until you can't see them.Too much peat soil will not hurt the seeds, but this is a waste.You only need to sprinkle a thin layer (until you can't see the soil).This step is very time -consuming, but this is very important.The coverage can play an important role in maintaining soil moisture. Do not water all the times a day (if you are lucky, you can once a day).If you don't buy toxic Fertilizers, fertilization can improve the soil, so that the soil becomes fertile.
Eleven, watering.
When watering for the first time, be sure to pour it thoroughly (ensuring that each area can be poured), which is very important.But don't pour too much water (don't make the floods).You have to water constantly, a small amount.After dampness (contact with water), the peat soil will show dark brown.The most important thing is not to leave any stagnant water.At the same time, the peat soil and soil must be fully absorbed, that is, at the beginning, you have to pour sufficient water.
12. Make sure to keep watering in the planting area.
Another advantage of peat soil is that through the color changes of peat soil, you can easily know when you need to water.When the peat soil becomes dry, its color will become light brown again, so you can knowIt is water.After watering, the peat soil will become wet, and its color will become dark brown.Ideally, the color of peat soil should always be dark brown (in other words, peat soil is wet).But the more practical approach is to pour water once before going to work, and then pour the water once after going home from get off work.If the peat soil does not dry, then you don't have to rush to water!Anyway, the color of peat soil is the signal indicator of watering.
13. Don't postpone the time of pruning the lawn for the first time.
The delayed trimming lawn will cause greater damage to the lawn.Once the new lawn reaches a trimming height or slightly exceeds this height, then you have to perform the first pruning.Generally speaking, the trimming height is probably6arrive8inch(15-20centimeter).Perhaps, when the first trimming time comes, your lawn still looks fragile.But the appearance is deceived.Just start your grass cutting machine on the lawn, don't worry about it crushing your lawn, because the grass is very flexible!If you let the lawn grow too long, then when you trim, they will be pressed down, and then the grass is cut off.So don't be afraid, as long as the grass is long enough, you have to risk cutting it off.
Special Mic 
